Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Avatar
spoonerj30
New Member
Last Activity: 07-09-2011, 08:40 PM
Joined: 05-08-2011
Location: California
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • Re: Gateway FPD1975W Power Supply (ILPI-021)

    After replacing the 47µf capacitors the monitor is still exhibiting the same symptoms. I'm not ready to give up on this. Please advise on how to proceed.
    See more | Go to post

    Leave a comment:


  • Re: Gateway FPD1975W Power Supply (ILPI-021)

    Okay, thank you PlainBill. Also thanks to jetadm123. I will report back once I've completed the final cap replacements.
    See more | Go to post

    Leave a comment:


  • Re: Gateway FPD1975W Power Supply (ILPI-021)

    So this test is assuming that one of the transformers is good and using it as a baseline?
    See more | Go to post

    Leave a comment:


  • Re: Gateway FPD1975W Power Supply (ILPI-021)

    Ah I see, it's 3% difference between the two readings.

    My multi-meter doesn't have 1K so I set it to 2K with the following results:

    T502 = 618Ω
    T501 = 629Ω
    Difference = 1.75%

    If you would, could you please explain why the [I]difference[/I] in this case matters?

    Yes I am going to replace the two 47µf caps with Panasonic FMs.Re: Gateway FPD1975W Power Supply (ILPI-021)

    Ah I see, it's 3% difference between the two readings.

    My multi-meter
    See more | Go to post

    Leave a comment:


  • Re: Gateway FPD1975W Power Supply (ILPI-021)

    I am a novice so I am unsure of my results.

    1. I used my multi-meter set at 200k Ω and with the red test lead touched pin 7 and with the black test lead touched pin 8 of one of the inverter transformers (T501, T502). The readout was 0.6. I repeated this on the second transformer. The readout was also 0.6.

    So these results show that the resistance between pin 7 and 8 are 6% which is twice as high as the suggested readout of 3%.

    2. I carefully checked the CCFL wiring and could not see any...
    See more | Go to post

    Leave a comment:


  • Gateway FPD1975W Power Supply (ILPI-021)

    Hello,

    The backlight turns off after a few seconds. The symptoms are like the following thread:
    [url]https://www.badcaps.net/forum/showthread.php?t=13844[/url]

    I've replaced all of the caps except the two Su'scon 47µf (red arrow in top pic). I am aware that Su'scon is in the list of bad caps but these two were not in stock at DigiKey at the time. I am going to replace these but I'm hopping that someone here has something to add.

    None of the caps that were replaced looked blown. All of the replacements were Panasonic FM.

    I have also read...
    See more | Go to post
    Last edited by spoonerj30; 07-04-2011, 04:48 PM.
No activity results to display
Show More
Working...
X