Yes, nothing is connected to the board, only power supply. Then it cycles two times and go to 0,023A
Lgolebio
New Member
Last Activity: 04-30-2025, 07:43 AM
Joined: 02-17-2021
Location: Wrocław
-
Re: MacBook AIR 1466 [ 820-00165-A] = Missing "PM_SLP_S5_L"
Yes, nothing is connected to the board, only power supply. Then it cycles two times and go to 0,023A
-
Re: MacBook AIR 1466 [ 820-00165-A] = Missing "PM_SLP_S5_L"
F7140 = 8,574V, as I said all voltages are fine up to PM_SLP_S5_L based on [url]https://logi.wiki/images/a/af/G3_-_S3_Ivy_Bridge_-_Broadwell.drawio.png[/url]
Even the battery charging works.Re: MacBook AIR 1466 [ 820-00165-A] ...harging works.Re: MacBook AIR 1466 [ 820-00165-A]Last edited by Lgolebio; 05-15-2023, 07:10 AM.Leave a comment:
-
Re: MacBook AIR 1466 [ 820-00165-A] = Missing "PM_SLP_S5_L"
It was replaced as I mentioned. And resistance is high.Leave a comment:
-
Re: MacBook AIR 1466 [ 820-00165-A] = Missing "PM_SLP_S5_L"
Sure.
Board is a little bit dirty with flux, because I replaced a capacitor and a TPS22924 switch.
...Leave a comment:
-
MacBook AIR 1466 [ 820-00165-A] = Missing "PM_SLP_S5_L"
Hi
MacBook AIR 1466
MB: 820-00165-A
I followed the power scheme [url]https://logi.wiki/images/a/af/G3_-_S3_Ivy_Bridge_-_Broadwell.drawio.png[/url]. I have all voltages up to "PM_SLP_S5_L" = 0V. When I plug the charger it tries to power on, goes to 0,250A then goes to 0,023A and does nothing. No fan spin.
I'm confused, board looks good under microscope. No corrosion.https://Hi <br /> MacBook AIR 1466<...wio.png[/url]. -
Sony PCG-71211M [no SUS_ON signal]
Hi
Motherboard:
M961_MP_MB MBX-224 [1P-0106j01-8011]
Laptop doesn't start. There is 3.3V on power switch. It reacts on that switch, turns on, but it only gets like 50mA of power. +5ALW is Present, +3ALW is present. No 3V on BIOS memory chip. There is no signal SUS_ON on Super IO.
Resistance to GND on all coils normal (kOhms and Mohms).
image [url]https://ibb.co/kQfQwPb[/url]
No idea what to check next.https://Hi<br /> <br /> Motherboard:... 3.3V on power -
Re: New Members - please post your introductions here
Hello to everyone. Great Forum ! I can't wait to post new thread
Leave a comment:
No activity results to display
Leave a comment: