victorioz
Member
Last Activity: Yesterday, 07:21 PM
Joined: 01-19-2021
Location: Magelang
-
Try to change npn transistor that produce enable. -
5v was too low. Try to check enable voltage on 5v ic regulator.Leave a comment:
-
Try to measure 1.8v and 1.0 v on each coil....Leave a comment:
-
Try to change crystal oscilator and 100ohm resistor near the crystal.Leave a comment:
-
Hello? Does anyone have asus gtx 1060 3gb phoenix/cg410l? Thank you.Leave a comment:
-
Re: 1050ti asus cerberous: 1.8v present, 1.8v pgood missing ..
Try to change 1.8v regulator.Leave a comment:
-
Re: Sapphire RX 480 - 8go no power - 0 volts à +VDDC - Help to find why
Did you find the problem?...Leave a comment:
-
Re: ASUS EX-RX570 all voltages present but not detected
Try to change network reistor array 330 beside the BIOS chip.Leave a comment:
-
Re: Artefact RX 560 Sapphire memory test attempt fails?
Use TServer for all AMD cards.Leave a comment:
-
Re: Graphics card Schematics and Boardviews
Hello everyone?
Does anyone have asus rx 470 strix board schematics?
Thank you for your attention.Leave a comment:
-
Re: GTX1060 not working, Vcore down to 0.3V
I had same problem with my Zotac GTX 950. I've been change the Voltage regulator (up1503V), 5v regulator, Crystal oscilator, and GS 7103. But the problem still appear.. Hope you'll find the problem.Leave a comment:
-
Re: Graphics card Schematics and Boardviews
How to download from that site? Because i did not understand russian language. Thank you....Leave a comment:
-
Re: Graphics card Schematics and Boardviews
Did try to connect with display port? Because sometimes the hdmi port not working.Leave a comment:
-
Re: Graphics card Schematics and Boardviews
Does anyone have gigabyte gtx 750ti schematic?Leave a comment:
-
Re: Graphics card Schematics and Boardviews
Did anyone have zotac gtx 1050ti schematic or boardview?Leave a comment:
-
Re: Graphics card Schematics and Boardviews
Thank you sir..Leave a comment:
No activity results to display
Leave a comment: