OK, I programmed 25Q40 modifyed by You and tried to turn on TV. No reaction.
Then i read a dump (in attachment). Thanks. Martin...
Martin_CZ
New Member
Last Activity: 10-09-2024, 12:51 AM
Joined: 01-05-2021
Location: Hlinsko
-
OK. I used same procedure for programming, verify was OK, so there is possible, that board has a different failure. But voltages are OK and there is no short at board.
Thank You very much for Your time. Martin...Leave a comment:
-
Good solution
Yes, I need to repair both of dumps in archive. OP 24082904 - already tested and working, but second dump OP 19020603 still not working. Red LED not lit, TV not turn on..
Martin...Leave a comment:
-
Dear friend, please modify this dumps. Thank You. Martin [ATTACH]n3460555[/ATTACH]...Leave a comment:
-
working. Thank You...Leave a comment:
-
please modily firmware. Samsung UE49MU6170. Many thanks. Martin...Leave a comment:
-
Dear guys. I spend about 8h with trying to repair RME Octamic II. There were 2 inputs bad - very strong noise at these inputs and signal very low. I tried to replace THAT1510 and NJM4580 to new ones, still same problem. Then i cutted tracks at input PCB (board with XLR connectors) and connected symetric signal from input 1 (bad) to input 3 (correct working before) at control panel. After this, input 3 was bad too. So I localized problem at input board. Finally i found bad serial resistor 4R7 Ohm (meassured about 8kOhms). After replace both of ressistors the device works correctly.Leave a comment:
-
working. thank You. There is a chance to do tutorial how to modify dump? -
Please I have just one dump for modification. Thank You...Leave a comment:
-
Thank You. It works!
One more question - how to modify dump? I checked some dumps form You from this side, I see differences from 0 to 01000 address but this countain is different from different dumps.
Martin -
Dear guys,
can I ask You for modification of this dump? Many thanks. Martin...Leave a comment:
No activity results to display
Leave a comment: