Re: Panasonic TC-P50x1 plasma
Thanks tom66, I'll try that.
Being a tech, I always clean connectors, I make sure they're dry (after a few hours or by compressed air) before re-connecting. I've run across dirty/corroded connections many times that were invisible to the naked eye.
To a non-tech: NEVER apply any liquid to an active electrical circuit/circuit board, as tom66 said, the electrons might get drunk. Nothing worse than a wasted circuit.
TrueReb
Member
Last Activity: 11-04-2017, 06:45 AM
Joined: 01-08-2011
Location:
-
Last edited by TrueReb; 08-18-2017, 08:15 AM. -
Re: Panasonic TC-P50x1 plasma
Have reseated ribbons 7 or 8 times now. Still have faint gray bars (never did have black solid). Getting tired of having this thing on my dining room table (wife too).Leave a comment:
-
Re: Panasonic TC-P50x1 plasma
yep, figured that. Cleaned ribbons with alcohol, better, but still faintly there. Downloaded the service manual and going to try a few resets then back to the ribbons.Leave a comment:
-
Re: Panasonic TC-P50x1 plasma
I ended up replacing the SU which fixed that problem. Now I have several horizontal lines in the top half of screen. Bad cap somewhere maybe?Last edited by TrueReb; 07-22-2017, 06:34 AM.Leave a comment:
-
Re: Panasonic TC-P50x1 plasma
Tried reseating several times. Maybe a bad buffer board?Leave a comment:
-
Re: Panasonic TC-P50x1 plasma
Thanks, thought the same thing, have reseated them 4 or 5 times, will go for a dozen.Leave a comment:
-
Re: Panasonic TC-P50x1 plasma
No takers?Leave a comment:
-
Panasonic TC-P50x1 plasma
I had the 7-blink of death. I ordered a new SC card from shopjimmy.com. The 7 blinks went away but now only the top third of the screen works, the bottom 2 thirds being black. Are there some resets I need to do or do I still have hardware issues in other areas?
I scoured the forum but didn't see similar posts. Sorry if this is a repeat. -
Re: Proscan 40LD45Q 40" LCD TV Help Needed!
I have a 40ld45q that has a broken lcd panel that I am scrapping. Shoot me your best offer for parts that you need. I know the power supply and inverter boards are good, as I do get a picture on the broken screen still. Best way to contact me is email at [email]ernie@computeremporium.net[/email] as I don't frequent this forum much.Re: Proscan 40LD45Q 40" LCD TV Help ...e power supplyLeave a comment:
-
Re: Sceptre x22wg-Gamer 22" LCD
Hi all,
I have X22WP-1080p that is working perfectly, however, I had a housefire that started in another room, but the heat got to my monitor and melted the top of the case.
My question is... does anyone know where I can get another case?
ThanksLeave a comment:
No activity results to display
Leave a comment: