Re: Belkin F5D4076-S v2 Powerline Adapter. Bad Cap and SCHOTTKY RECTIFIER



I finished up removing the same cap and SCHOTTKY from the other working adapter to confirm it. Turns out the cap is the issue. I've ordered one up and should be here shortly ...

Re: Belkin F5D4076-S v2 Powerline Adapter. Bad Cap and SCHOTTKY RECTIFIER

Thank you very much for your help

Re: Belkin F5D4076-S v2 Powerline Adapter. Bad Cap and SCHOTTKY RECTIFIER



Thank you for helping me.

With caps am I correct that I can replace it with a higher rated cap then 2200uF as long as the 6.3 voltage is the same. Just not lower than 2200uF?

And also any Electrolytic cap will be fine?

With the Shottky. So a 3A but is the voltage not important?

Thanks

Regards
Neil...

Hi,

Firstly I'm quite the amature at fault finding.

I have a pair of Belkin F5D4076-S v2 powerline adapters. One is working the other is dead.

On opening the dead one. I spotted a bulging cap which is a 6.3v 2200uF.
Measuring it with a MM reads 1900 uF.

There is also next to it a SM SCHOTTKY 399F SM340C. On testing this for continuity there is none. However on testing the other powerline there is continuity. So looks like I need to replace that also.

I cannot find any Schematics for the powerline. I've been able...

Re: New Members - please post your introductions here

Hiya,

From Sheffield, England looking to find some help regarding my pioneer hm72 amp that suddenly died.

I've found a tiny bit of information on the net about this amp as I've not come across any Schematics.

Hope to help where I can too, although my knowledge is limited :|