spantor
Member
Last Activity: 05-31-2025, 08:25 AM
Joined: 01-26-2020
Location: madrid
-
Unfortunately, it didn't work. Maybe it's the EMMC memory or just a defect in the motherboard. It's a shame.​... -
Would you be so kind as to check tcom firmware?​...Leave a comment:
-
I understand. You may be right, and it's not that firmware that's faulty, but perhaps from another memory. My options are coming to an end because I don't have an EMMC programmer.. Thank you very much for your help.Leave a comment:
-
Hello.
Is model BN41-02528, code BN41-02528A
You firmware not working. The symptoms are: it turns on and the logo appears for a second, then the TV turns off. After waiting a minute the backlight comes on, it turns on, but there's no picture. The stand by lights flicker when you press buttons.
I still suspect the firmware.
I hope my programmer is not a problem.​...Leave a comment:
-
FIRMWARE SAMSUNG UE50KU6000K
Mark: Samsung
Model: ue50ku6000k
Chassis (main board, components): 2n4102528
LCD Screen/Panel (if exist): cy-gk050hhnv1h​
Hello.
I suspect the firmware is corrupted. Could anyone send me a working one?
Or fix this one.
It was read with SOFI SP8A.
Thanks... -
power board manual philips 55pus6482/12 715g-p01-000-0h2s
Hello.
Some components have exploded and I can't figure out the values. I have obtained the manual for this power supply for 65" but comparing components there are some differences and it is not reliable.
Could someone leave me the power supply manual for this 55" model?
I would be very grateful -
I think I can rule out PB. The easiest thing will be to buy a used MB and wait for luck. Thank you for all your patience and knowledge. If I can help you with anything, don't hesitate to ask me.
​...Leave a comment:
-
I can confirm that between pin bl and pin gnd there is no voltage when turning on the tv.
Pins 110vac and 50vac should be measured in alternating current? I thought that VAC refers to alternating voltage current...Leave a comment:
-
apologies I think VAC voltage I have measured with continuous voltage. I will measure again...Leave a comment:
-
there is no voltage. but there is voltage between positive pin and chassis. there is 190v. negative pin does not close the circuit...Leave a comment:
-
The measurements I have made so far have only been in cn3Leave a comment:
-
Dim 0.... 0v
Dim 1..... 0v
Dim 2.....1,6v....Leave a comment:
-
This board have another board for leds...
Leave a comment:
-
There is -5.31voltage between pin bl and gnd when I turn on the TV. Then the voltage disappears definitively at the end of the cycle of the two flashes of the standby LED...Leave a comment:
-
standby has around 3v when I turn on the tv.The problem is that the standby leds make 2 flashes and then the TV turns off.When TV tries to turn on there is no any image and there is no back light, however there is 90v in the LED backlight + cable but there is no - in the LED backlight cable.I have my doubts about using this power board, for that reason I want to turn on this power board without the main board connected...Leave a comment:
No activity results to display
Leave a comment: