Hello again gubbie i was just wandering if you had forgot about me?
just to give you more information the resistor is on the power supply board of the Vizio VA26LHDTV10T
The Number is #R933 here is a picture of the board and the circled part for location referance
...
gubbie
Member
Last Activity: 02-06-2025, 12:47 PM
Joined: 12-14-2010
Location:
-
Hello gubbie i have a Vizio VA26LHDTV10T same as you on my power supply board i have a burnt resitor on R933 could you give me the color code of that resitor it would be greatly appreceated
Thanks in advance -
Re: Vizio VA26LHDTV10T Sound but no picture
My issue was resolved by the replacement fuse. I do not recommend what I did, but it worked for me. I purchased an inline fuse holder and soldered it to the solder pads. I was temped to run them to the outside of the monitor, but there was plenty of room to keep the fuse inside of the case.
Thank again to every one for their help. -
Re: Vizio VA26LHDTV10T Sound but no picture
Fuse F1 is bad. I hope that is the only issue. I will replace and test. I will stay away from the top forth of the board.Leave a comment:
-
Re: Vizio VA26LHDTV10T Sound but no picture
I checked the 7A one. Where is the second fuse on the inverter?Leave a comment:
-
Re: Vizio VA26LHDTV10T Sound but no picture
that cap is labeled as 250v. Would you normally expect higher than 250v across it at that point?Leave a comment:
-
Re: Vizio VA26LHDTV10T Sound but no picture
I actually discovered that I bent pins in the two CCFL connector, but I am still searching for a solution. Should I be getting a voltage reading across the big blue component. It reads zero.Leave a comment:
-
Re: Apple Cinema Display 23", Acrylic - Problems
AggeLON,
I am curious if you found anything with the signal board. I have same monitor that light up all the time. All CCFLs are on. I can see a very faint that the display actually has video, but it is very faint. I will post a picture if I can tonight.Leave a comment:
-
Re: Vizio VA26LHDTV10T Sound but no picture
Here are the new pictures that I was able to take. I am sorry if the dimensions are too big. I did not want to loose any quality. I am about to leave work, but I noticed the two left CCFL plugs are not seat correctly. I am sure there is nothing wrong, but as many times as I have unplugged them recently, I better check for bent pins......Leave a comment:
-
Vizio VA26LHDTV10T Sound but no picture
I have a 2.5 year old 26" Vizio that all of the sudden came up with the old no picture. A flashlight test verified that the screen is fine. The Vizio branding turn white when it is turned on.
I suspect this inverter (VIT70063.50 REV:3) has been problematic due to how many places sell replacements.
The first pictures show R26 being discolored. My meter measured around 68K on R26 and R34 measured around 70K for a comparison. I am getting 24V off the PSU. The 7A fuse directly off the 5 24V pins is good.
I get the following readings through pin 4 and... -
Re: New Members - please post your introductions here
Hiya,
My name is Kevin. I live in Corvallis OR. I enjoy my friends with simple electronic repairs. I grew up with a father that could fix almost anything electronic. Honeywell field engineer covering most of New England. Brief case of tools and a scope in the truck of his Fiat Spider.
I should have paid more attention to his ramblings as a kid. Thank you for existing!!!Leave a comment:
No activity results to display
Leave a comment: