Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]

Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Avatar
zsuhaa
New Member
Last Activity: 08-25-2020, 01:16 AM
Joined: 08-02-2019
Location: Budapest
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • Re: Panasonic P65VT60 reset loop

    Hi,
    I have bad news: my TV is broken again with the same problem, and I should find a replacement Main board, because they can't repair it they said.
    Yes, 13 blink means main board error as you guessed.

    You might send your main board for EEPROM replacement/reflashing and Main IC resoldering, it might help, or not. In that case they would check the whole main board of course.
    But they wont be able to test their job without the whole TV.
    I don't know why they don't respond to you, maybe they just don't want to accept...
    See more | Go to post

    Leave a comment:


  • Re: Panasonic P65VT60 reset loop

    Hi,
    I was just reading your problem. I can only suggest you to get contact in email with these guys, this is a local TV service business in Hungary, Budapest. Their email address can be found on their website. [URL="http://www.alfatvszerviz.hu/"]http://www.alfatvszerviz.hu/[/URL]
    That will be a main board shipping to you back and forth to Hungary as well.Re: Panasonic P65VT60 reset loop

    Hi,
    I was just reading your problem. I can only suggest you to get contact in email with these guys, this is a local
    See more | Go to post

    Leave a comment:


  • Re: Panasonic P65VT60 reset loop

    Hi everyone. Just to post the conclusion:
    my technician friend managed to repair the TV at their local TV repairing business.
    The NAND flash was removed (IC8900), and a new one was reprogrammed with the old one's contect and soldered back into the MB.
    The main IC (IC8000) was removed and resoldered as well, because the original soldering hasn't aged well: cracks were seen when observed with microscope before removing.
    Now the TV works fine. These guys are good at their job. They can also change smd-s, whatever is needed....
    See more | Go to post

    Leave a comment:


  • Panasonic P65VT60 reset loop

    Hi everyone, I just bought a faulty VT60 from my friend (for 200 Eur) and trying to fix it with a friend. It has 15000 hours running, I did a factory reset recently, and it has the newest firmware (version 3885 for EU).
    Symptoms are the following:
    1. if I dont try to switch it on for a day, then it switches on correctly and works as normal for 10-15 mins. After that point (interestingly, usually, when I try to do something other than just hanging in the menu, e.g. try to start a youtube video),
    2. it starts to resetting itself: resets, works for 15-30 sec, and resets again. Audible...
    See more | Go to post
    Last edited by zsuhaa; 10-03-2019, 11:53 PM.

  • Re: New Members - please post your introductions here

    Hi everyone. Quick introduction from me, I'm here to find help repairing my tv.
    I'm an enthusiast, and electronic is one of my pastime, so I think I'm at the right place.
    See more | Go to post

    Leave a comment:

No activity results to display
Show More
Working...
X