Re: Marshall Stanmore Repair

It's done !!! Yeahhhh, I've fixed my problem and the Stanmore plays again.
First, it's important to distinguish which model you have, for me it's the european one, with the switch "PowerSaver/Standard" at the rear of the box. The importance is that on this PCB, there is no resistor R23.
So, as wrote Chris J in the post #62, I put a resistor R23 (220 Ohms) as he did (see the post #62). What a miracle !!!
Please, don't replace any other component before soldering this R23 and test.
Before I find my solution, with the big...

Re: Marshall Stanmore Repair

Hi Hann,
I've read your post with great interest.
My Stanmore is also down, no led on at all, just earing a little click, for a few seconds, at the start.
No success after replacing the MC34063A, the LM317T and FMG23S.
So I would like to make your solution (replacing the 3.3/50), but I don't see it on the PCB...
Could you please give me its place and its reference ?
Thanks a lot.
Best regards.
Michel (from France).