Hi everybody!

I wanna buy Atten 938D soldering station, [url]http://www.ebay.com/itm/ATTEN-SOLDERING-STATION-AT938D-60W-Thermo-control-NEW-/160784734820?pt=LH_DefaultDomain_0&hash=item256f845a64[/url]

The soldering iron does not have the sensor, only the heater, 2-core. Is there a way to use it with the other iron having 4-core heating elenment with the sensor by making some mods maybe?

Thank you in advancehttps://Hi everybody!<br /> <br /> ...6f845a64[/url]...

check my Re: Westinghouse LCM-20v5 comment.

Re: Westinghouse LCM-20v5

I found a Chinese site where is a lot of DELTA schematics, [url]http://www.wjel.net[/url], it is a Chinese forum so I MUST be registered there but I don't know Chinese Maybe somebody knows how to get registered there as English-speaking person. Also possibly there is a SIMILAR schematic(s) in this forum or anywhere else: two groups of lamps, two transformers, four mosfet chips, OZ964GN chip?Re: Westinghouse LCM-20v5<br /> <br...orum so I MUST

Re: Westinghouse LCM-20v5

Thank you VERY MUCH, all of you for your attention and patience! I will use all of your advices and if I will find something interesting I of course will post it. I uploaded manual for said Acer AL1916Wc-1 LCD monitor. It's my small gift for all of you...

Re: Westinghouse LCM-20v5


Resending picts 2000x1500 plus back side of inverter plus capacitors (similar, not same ). EVERY JOINT EXCLUDING ON-SURFACE COMPONENTS WERE RESOLDERED carefully, I have a small experience in soldering

Please to everybody: this DAC is used by a lot of brands in particular by Acer AL1916Wc-1 LCD monitor, I have the service manual for it and can upload it for everybody (don't now how to, give me an advice how, I'm newbie )
This manual has a circuit diagram but in my opinion not a diagram of said DAC, but of a...

I have LCD monitor Westinghouse LCM-20v5, inverter/power supply DAC-12M030B Rev1F. If it starts to work from cold condition it waits about 1 sec to show normal image. Then it works fine about half an hour, then it becomes blank. Turn off/turn on – goes to "2 seconds to black" condition. I think that it's a backlight issue because when I use flashlight, there is badly visible image on screen. First of all I resoldered all joints excluding on-surface components. Then I changed 6 capacitors for new ones (I found it by googling “Westinghouse LCM-20v5”). No changes.
Then I tried...