Re: Panasonic TX-PR50G20 vertical bar
Tell me, can this be software damage? Eeprom firmware will not help. Only replacing ic?...
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Re: Panasonic TX-PR50G20 vertical bar
Checked many times. I changed the cables, cleaned the connectors....
Leave a comment:
-
Re: Panasonic TX-PR50G20 vertical bar
Sorry for my bad English, I am writing through a translator.
Yes, it turns out he stole, replaced by non-working tnph0838.
So I bought the same TV with a broken screen. And I took tnph0838 from it.And I got a vertical bar.
On a TV with a broken screen. I found a burning address loop driver. Just in the place where I have a vertical bar. Could it damage tnph0838?...
Leave a comment:
-
Re: Panasonic TX-PR50G20 vertical bar
It was not. Initially, there were 4 blinks on the TV, it burned down SC Board TNPA5081.Found in another city master, who took up the repair SC Board TNPA5081.And at the same time asked to send him to check main TNPH0838.
TNPA5081 he did not repair, sent another working fee. And instead of mine TNPH0838,sent another with 42 inch models and not working. And the master was gone, the phone does not take. I had to look for another main tnph0838.
I tried to put another C3 Buffer Board TNPA5101,The problem did not solve,...
Leave a comment:
-
Panasonic TX-PR50G20 vertical bar
On my tv Panasonic TX-PR50G20,there was a bad pay main TNPH0838.For the replacement I bought, the exact same TV with a broken screen. I took it off main TNPH0838,I put it on my TV. It started up, everything works, but on the screen there is a light vertical strip, approximately 7,5см (3inch)....Last edited by fant83; 01-07-2019, 02:55 AM.
-
Re: New Members - please post your introductions here
Hello, i'm new one!
Leave a comment:
No activity results to display
Show More
Leave a comment: