Re: New Software Achi LY by PSOFT

I was able to get the software to work with my Achi IR6500. I don't know if this is the correct post for this thread and do apologize if it isn't, I've run into another slight problem. The Altec PC410 controller displays probe temperature as a negative integer. Meaning it starts out at 20/21 C (room temperature) and as the temperature gets hotter, the displayed value decreases, eventually reading a negative number (-20). I've been googling trying to find a solution. If anyone here knows anything or can point me in the correct direction I'd greatly...

Re: New Software Achi LY by PSOFT



Thank you so much for your fast reply!

I seem to have run into another issue. When I try and open a COM port to my ACHI IR6500 via a USB to USB cable to a windows 10 laptop, I get an error message that say "port COM1 does not exist" When I plug the IR6500 into the laptop it does seem recognize it. If I could get some help on resolving this issue I'd greatly appreciate it. This is my first rework station and I'm just trying to get it up and running. Thanks for your time....

Re: New Software Achi LY by PSOFT

Hello all. first time poster. I downloaded the Psoft software. I am on windows 10 and can't seem to figure out where to put the language file so the application will translate to English. Any help would be appreciated, thanks.

Re: New Members - please post your introductions here



Hi, thanks for a great forum...