Re: iiyama 24" E2407HDSV [DEAD]
I have 0.035V going in white connector, and yes those pictures are from web unfortunately, But I tried my best to shoot mine. [url]https://imgur.com/a/EJcrJuV[/url]Re: iiyama 24" E2407HDSV [DEAD]<br /.../EJcrJuV[/url]
ivanoxx
New Member
Last Activity: 10-28-2018, 11:05 PM
Joined: 09-18-2018
Location: Slovakia
-
Re: iiyama 24" E2407HDSV [DEAD]
Could Faulty OZ9937GN lead to monitor not turning ON? Even if its IC for CFL. what component of the monitor is Turning monitor ON if PSU has every voltage right - potentionaly.Leave a comment:
-
Re: iiyama PSU repair from LCD monitor [fixed]
Yes i did. And pictures of my board are in my newly created postLeave a comment:
-
Re: iiyama 24" E2407HDSV [DEAD]
[url]https://imgur.com/a/yU9um5v[/url]
this is the board
IC LD7576PS has in datasheet:
On/Off Control
By pulling COMP pin lower than 1.2V will disable the gate
output pin of LD7576X series immediately. The off mode
can be released when the pull-low signal is removed.
what does this mean?
then this : Over Load Protection (OLP) - Latch mode
"... As soon as the
over load condition is removed, the controller will be kept
latched...Last edited by ivanoxx; 09-18-2018, 05:43 AM.Leave a comment:
-
iiyama 24" E2407HDSV [DEAD]
Hi lads, I've been trying for several months (mostly waiting for parts) to repair my monitor. Before its definitive death, monitor was shutting off and on repetitively and then it just died. Led is not lit, completely dead. Now i have replaced all caps, fuse, and mosfet. I tried to replace IC LD7576PS which didnt help me. ( [url]https://cdn.badcaps-static.com/pdfs/4e4ba7fe3d09f659f651d6ce119f6336.pdf[/url] ) here are schematics, different monitor, same psu.
What else could it be? What component is "triggering" something so it could start up.Hi lads, I've been trying forLast edited by ivanoxx; 09-18-2018, 05:38 AM. -
Re: iiyama PSU repair from LCD monitor [fixed]
I need to confirm if my PSU is OK.Leave a comment:
-
Re: iiyama PSU repair from LCD monitor [fixed]
I have same monitor, Can you help me? Mine is totally DEAD, i replaced the Mosfet , IC which is ld7576PS , every cap, big+small ones, i replaced blown fuse and my monitor is still completely dead. on output from PSU to inverter i have 5Volts and one is 3.3V I think. Is that Correct?Leave a comment:
-
Re: New Members - please post your introductions here
Hello, I'm new here.Leave a comment:
No activity results to display
Leave a comment: