Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]

Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Avatar
CesarTurboPC
Member
Last Activity: 10-15-2023, 01:29 PM
Joined: 07-11-2018
Location: Hidalgo
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • Re: Samsung UN55MU6103F IC1604 dump

    Thank you lotas, you are crack, it works correctly.

    I should mention that it must be programmed with the CH341.

    Programming instructions with the AsProgrammer program.

    In the program:
    1. Click "Detect Chip" and select W25Q40CL and "Select IC".
    2. Click "Unprotect".
    3. Click "Clear IC" and "Yes".
    4. Click "Open File" and select your corrected dump.
    5. Press "Program CI" and "Yes".
    ...
    See more | Go to post

    Leave a comment:


  • Re: Samsung ue49mu6120



    Thank you very much, I'll let you know how it goes, I tried to program it with the EZP2019+ but checking previous answers you can only do it with the CH341, right? for protection? Are is right?

    Muchas gracias, ya les cuento como me va, intenté programarlo con el EZP2019+ pero revisando respuestas anteriores solo se puede hacer con el CH341 verdad? ¿Por protección? ¿Es correcto?...
    See more | Go to post

    Leave a comment:


  • Re: Samsung UN55MU6103F IC1604 dump

    schematic of the power source.

    Model: BN44-00807A...
    See more | Go to post

    Leave a comment:


  • Re: Samsung ue49mu6120

    Hi
    I have the same problem. Can you help me ?
    Thank you....
    See more | Go to post

    Leave a comment:


  • Samsung UN55MU6103F IC1604 dump

    Could you help me... I have a Samsung UN55MU6103F with the following problem, dead TV, I disconnect the main power supply and the leds light up. I know it is a problem in the firmware in the IC SPI Flash W25Q40CL (IC1604)

    The model of my TV is
    UN55MU6103F
    Power supply BN44-00807A
    Main Board BN41-02568B

    Could you help me to repair the dump please. Thank you.

    I leave my backup of the dump and a little extra, it is the schematic of the power source, it can be useful to someone. Regards



    Me podrian ayudar... tengo un...
    See more | Go to post
    Last edited by CesarTurboPC; 01-31-2023, 01:12 PM.

  • Re: Asus X455L schematic needed..

    ASUS_X455LD_2.1 (BDV)
    #SCHEMATIC
    #BOARDVIEW

    ...
    See more | Go to post

    Leave a comment:


  • Re: Need *schamtic forHP For Probook 450 G5 DA0X8CMB6E0

    What's up colleagues, since there is no schematic or boardview anywhere, I would like that between all of us we can get information on this board.

    A machine of this model arrived to my workshop, which does not turn on.

    I put it to the laboratory source and it immediately consumes 0.320A.


    It begins to raise heat in the part of the processor.

    And I have some voltages when I connect the charger.

    It does not turn on any light. ...
    See more | Go to post

    Leave a comment:


  • Re: HP Pavilion x360 Convertible - Identify shorted Power IC




    I know it's a little late but it may help.

    PIN 1 -Boot-strap pin. Supply high side gate driver.
    PIN 2 - PIN 3 - PIN 4 - PIN 5 - VIN
    PIN 6 - PIN 19 - PIN 20 - The VOLTAGE depends on the circuit, commonly connected to the output coil. In the example image we have 3.3V. This happens when the equipment is turned on, while it is in stanby it has no voltage.
    PIN 7 - PIN 8 - PIN 18 = GND
    PIN 9 - Power good Indicator.
    PIN 10 - PIN 16 - NC
    PIN...
    See more | Go to post

    Leave a comment:


  • Re: lenovo IdeaPad S145 bios needed

    Hello Peste, could you please help me with my corrupted BIOS, it is from an IdeaPad S145 14IWL please. I would really appreciate it. Thanks.
    See more | Go to post
    Last edited by SMDFlea; 04-10-2023, 08:44 AM.

    Leave a comment:


  • Re: lenovo IdeaPad S145 bios needed

    How's everyone. Someone help me, I leave my original bios, the computer only turns the power button on and off and does not give video. In the power source it remains at 316 mA and does not do more.

    Model: Lenovo ideapad s145-14IWL
    Main board: FS440 / FS441 / FS540 NM-C121 Rev 1.0

    Greetings and thanks for your valuable help.
    My English is a bad thing, excuse me.

    :salud:
    See more | Go to post
    Last edited by SMDFlea; 04-10-2023, 08:44 AM.

    Leave a comment:


  • Re: need bios dump acer aspire v5 472



    How about colleagues, could you help me with the EC of this model? The main file you shared seems to work but my EC is also damaged. I don't know if you can share it, it would be very useful. Thanks a lot. :inclinarse::inclinarse::inclinarse:...
    See more | Go to post

    Leave a comment:

No activity results to display
Show More
Working...
X