Hi, anyone got panel firmware
17Mb110
VES500UNDC-2D-N12
Thanks In advance...
Ben198585
New Member
Last Activity: 09-04-2024, 02:42 AM
Joined: 05-29-2018
Location: Sussex
-
Re: Panasonic 58-TXAX802B Stuck on Panasonic Logo
I have a few.
AX902
AX802
Mains with boot loopLeave a comment:
-
Re: Panasonic 65fx700b intermittent tcon problem
It was actually a t-con from a TX-65FX600B...Leave a comment:
-
Re: Panasonic 65fx700b intermittent tcon problem
I fixed one of these t-cons on the same model.
There's a single S.M cap at the very top middle of t-con.
Replaced it and fixed.
I found out by applying 3 seconds of hot air on the t-con just before you turn on the tv, panel will come on and stay on. Until you turn it off, then reheat repeat.
Or just Replace cap mentioned
Also 55" tcon won't work, been thereLeave a comment:
-
Re: Panasonic 58-TXAX802B Stuck on Panasonic Logo
I just downloaded both service manuals, then compaired both power boards and main boards to put correct pin 2 pin.
It does get very confusing lol... As long as you check your wiring 3 time over before you switch it on.
I wired the B/L on to the standby button, and when you turned tv off with remote it didn't turn off the B/L.
So that was the only thing that wasn't perfect!!
but just ment turning it off with the button on the side instead.Leave a comment:
-
Re: Panasonic 58-TXAX802B Stuck on Panasonic Logo
Thanks my friendLeave a comment:
-
Re: Panasonic 58-TXAX802B Stuck on Panasonic Logo
Hi, jumping in on the end of this talk about the poor fast dying model the TX-**AX802.
I have some good news!!!
I picked up a main board from a TX-**Dx902 flagship model off the bay for £40 (not bad compaired to £150)
If one ever turned up on the bay, it would most definitely end up going bad. A Bit like a £150 ticking time bomb lol...
A little bit of modification to back cover with the metal snipped & removal of the 5 aux ports on top of the main board, also add putting...Leave a comment:
No activity results to display
Leave a comment: