ok... well i just want to be sure, i thought that uF values shouldnt be changed.. that only voltage could be (higher that is)...

also should i replace all the 1500uF caps? most 'seem' ok... there were only 2 that were leaking, granted the others could still be bad...

one other question. which two 1000uF caps would be the ones replaced by the ones included in the set?, i noticed that only two 1000s are included. but theres more than that on the board

i also have an abit ka7-100
caps, also leaking... they are all JPCON
but i noticed that on the image above, (the first one) the taller caps pictured in the group of 4, are rated at 1500uF, while the ones on my board are rated at 2200uF, ive already replaced all of my 2200uFs with new ones, as they showed the most bulging and leaking..

and another next to the dimm slots (the outside edge right in the middle below two other 2200uF caps)

my question is then should i have replaced the 8 caps that were 2200uF before with 1500uF ones?

i also...