Re: What about all these SMD capacitors with no marking?

somewhere I did see a data sheet on these, it goes by size and shape. there is a card you can buy that has them all on and you put the one you have on the card and match it to the size and shape on the card. i have one some were.

Re: Samsung LE26R88BD Strange Fault (Main Board??)

Thanks steviewonder. replaced them capacitors. C1110 had 4.1% loss C1177 had 1.4% replaced them both with 1000 AFP 6J5 105C. had to order a new solder station as this one has packed in so using gas iron, will finish off when new iron station arrives. thanks

Re: Samsung LE26R88BD Strange Fault (Main Board??)

I Have A very similar problem but in reverse. when cold will not turn on leave it for 15 min it will turn on. i've checked the 1117 on my reader, one comes up as uf = 1.34v c= 84. 8uf and says diode. 0ther one says diode as well uf = 1.34v c= 0nf. and warm in hand c80.6uf and longer c84.8uf. this 1117 is from ic1106. ->l- flow. ic1107 stays steady at any temperature. order theses NCP1117 regulated not fixed. 1A 2.5v min 12v max. handels upto 20v. in. see if these repair the board.

Re: Samsung LE32R88BD/ BN44-00155A

Hi, i'm new, I have the same board for the 32inch model, had a bad capacitor 10v 1000uf replaced this and would not turn on, i tried the things mentioned in this post,. on its own it will turn on after 15 minutes, resistor in rm801 checks out fine, capacitor cm861 had blown cap. replaced this. 24 volts fluctuating around 12 to 17 volts and slowly goes up to past 24 volts then tv turns on, this is on cm802 (s) any ideas on this. previous own used tv for cctv and was on until a power cut. does work fine after its been trying for 15 minuets.