Re: Sceptre X9G-Komodo II* blinking power light





The same problem was with mine monitor.

Can you try first disconnect upper lamps from board, and then start monitor, and if you see picture for the second the problem is on the lower side of the board, you can disconect lower lamps and comfirm this. Or oposite. When you find the side you shoud remove transistors and check oposite legs for shorts. If one is short this one is bad.

Is one is short replace boath. Do not try with ony one becouse is will kill the good one....

Re: Sceptre X9G-Komodo II* blinking power light

I have replaced all caps,resolder all bad/suspect solder joints, and replaced Q6 and Q7 with similar ones, after that monitor works. After I removed Q6 form board I tested it and it was shorten. Q7 was ok, but I replaced it just in case.