Maniacks62
New Member
Last Activity: Yesterday, 12:49 AM
Joined: 11-15-2017
Location: Odranec
-
You're great, thanks for your help. I covered the contacts and figured it out. Something went wrong with the display in the lower left. You can see it in the attached photo....
-
Tested. After connecting the CN1301_UT connector, no image is displayed on the TV. With the CN1300 connector, the right half of the TV works....Leave a comment:
-
In the first case, I had it soldered incorrectly.
pin 1 (connector CN1300), last pin (connector CN1301_UT)
I just tried it, the TV does not restart. It can be controlled with both LVDS connectors connected. The image does not appear even with one connector disconnected....Leave a comment:
-
Unfortunately, it's still the same....Leave a comment:
-
I'm not sure what panel number you want....
Leave a comment:
-
I made a jumper. The TV remains on and controllable by both LVDS cables separately (only backlight, no picture, but responds to the remote). If I connect both cables, it flashes again and is uncontrollable.
I would be grateful for any advice. thanks...Leave a comment:
-
Hello,
After connecting to the mains, the backlight immediately starts flashing and no TV image can be controlled. When the connectors to the display are disconnected, the backlight is on and the TV can be controlled....Leave a comment:
-
Dobrý den,
toto je výpis z ue50mu6172u, můžete to opravit?
Díky....Leave a comment:
No activity results to display
Leave a comment: