Re: Philips Plasma 42" troubleshooting help?



In this case the relay is not turned on. There is no click....

Re: Philips Plasma 42" troubleshooting help?

Wow! Thanks Bill! I would have been plunking around for days looking for that!

I found Zero volts at 8V6 with system plugged in and in protect mode. I'll check all of the voltages in this manual for my board. Should I put it in Service Mode for this? For some reason I get the feeling that all of these points might be without voltage due to protect???

There are two green LED's on the board that do not light up when the system is plugged in and in protect mode. I hear a slight ringing sound from the Hot...

Re: Philips Plasma 42" troubleshooting help?

I'll check the light on the board. This above blinking code description is from the front "standby" LED indicator. I'll also get a measurement on 8V6 when I get home from work here in a few minutes.

Striking out on finding that panel service manual. I'm assuming that the Assy Code on the board (LJ44-00117A) would be what I search for? There is also a PS-425-PH Rev 0.2, but I've not found it yet with either.

Thanks for the reply!

Hi guys,

I've got a model 42PF9631D/37 Philips Plasma TV. Chasis number BJ2.5u PA. This unit goes into protection immediately after being plugged in. The power button does nothing to change the symptoms. The red LED is displaying 7 short blinks then pauses, then repeats. I cannot see a long blink in the pattern. Sounds like a code 7 to me??? This code "7" has a description of "8V6 supply" in the service manual.

I have another TV just like this one that I've repaired by replacing two caps (C8059 &. C8060). I took the power supply board out of...

Re: New Members - please post your introductions here

Corbino here, been looking around here for a coupla hours and have found more information than I did all day yesterday! Badcaps!