Re: Denon RCD-M40 "Protection Mode: Power", couldn't reset.
I suspect that too, so where to start with? Any suggestions?
JidhinGeorge
New Member
Last Activity: 07-25-2021, 08:54 PM
Joined: 06-30-2017
Location: Abu Dhabi
-
Re: Denon RCD-M40 "Protection Mode: Power", couldn't reset.
Is this could be a weak capacitor, the culprit? I have this feeling since it worked fine for several hours and then I removed the main power overnight and plugged in the next day to see the error again!Leave a comment:
-
Re: Denon RCD-M40 "Protection Mode: Power", couldn't reset.
Thanks for replying, I have the service manual and I did a solder reflow yesterday to all the individual PCBs after taking apart each boards and the fault cleared, worked for a day. But on turning the power ON today it went bad again. Same fault. Attached service manual to the post here.
Thank you....Leave a comment:
-
Denon RCD-M40 "Protection Mode: Power", couldn't reset.
I have this Denon RCD-M40 with protection mode: power ON always! I cannot reset and I can't use the system by any means! Anyone has a fix? There was line voltage fluctuations for the past couple of days and is now fixed. The receiver was working fine even after that on reset but now this error again and stays ON all the time, right away on plugging the power cord....Last edited by JidhinGeorge; 11-21-2020, 12:25 AM. -
Re: Subwoofer auto on/off: Taga Harmony Platinum SW-10 v.2
Hello, I have recently purchased this subwoofer and I'd like to know your suggestions and opinions. How does this sound? The specs sheet says it can go down to 20Hz, does it sound good at 25-30Hz? I have preferred this sub over Polk Audio and Wharfedale. Thank you....Leave a comment:
No activity results to display
Leave a comment: