Hi,
Many thanks for your reply. The inductors show very little resistance as expected and the caps around 20-40ohms to gnd. Without battery the tablet does not power up if charger is just connected.
With battery and charger connected (when powered up) it shows connected to charger but as I said earlier it takes power from the battery until it goes flat and the unit switches off.
When the charger is connected when powered up the icon on battery moves like it is taking a charge but stops after 10 seconds.
Hope this helps and look forward to any tips on what I should...

Thanks obelix24 for your feedback. Really appreciate it.

Hi,
I have a Aer table which does not charge. When I plug in charger the bars in the battery icon move for about 10 seconds and then stops. It does not put any charge into the battery.
It switches on fine and works as it should bar the charging. The orange led to show charging is lit as well.
I have had a look at the board and cannot see any shorts or burnt components.
Hoping someone will have any experience of this fault.
Any tips on where I should be looking would be greatly appreciated.
Thanks.

Hi,
I know this topic is over a year old but did you get any joy with this repair? Did replacing TSP61030 help?
I have a Switch 10 tablet which powers on and when charger is plugged in the charging bars move for about 10 seconds and then stops.
It doesn't take a charge. I cannot see any shorts or burnt components so need a bit of advice.
Is it ok to post on this or start a new topic?
Thanks....

Re: New Members - please post your introductions here

Hello to everyone. I try to repair everything and anything....safely. This can be from mobile phone to cars.......all to save a few bob!
Nice meeting you all.

Jet