Re: Toshiba 46g300u3 screen turns off after hours
It's not automatically turning off. That setting is off. I'm not at home I'll get voltages then.
BestYohman
Member
Last Activity: 11-20-2022, 10:50 AM
Joined: 02-21-2017
Location: Hubbard, OH
-
Re: Toshiba 46g300u3 screen turns off after hours
My thought was if it was over heating it wouldn't come back until cool. It comes right back on no issuesLeave a comment:
-
Toshiba 46g300u3 screen turns off after hours
Toshiba 46g300u3 screen turns off after about 2.5 hours. The power light stays on and the chrome cast I have remains powered. Sound does not continue also the backlight is off. The TV will turn back on immediately and stay on for another 2.5 hours. When it goes out the screen turns off followed by the sound 3 seconds later.... -
Re: Toshiba 46XV64U 3 Blinks but still turns on...
no thoughts?Leave a comment:
-
Toshiba 46XV64U 3 Blinks but still turns on...
I have a Toshiba 46XV64U that blinks 3 times pauses blinks 3 times pauses then blinks 3 times again. After that it doesn't blink but it is able to turn on... Replaced a resistor on it and the relays on the power board. Everthing functions fine on the tv just does that 3 blinks thing -
Re: Toshiba bad resistor
OK thank you for all your help!Leave a comment:
-
Re: Toshiba bad resistor
ok then the only thing now is ordering the proper resistor... correct?Leave a comment:
-
Re: Toshiba bad resistor
tested it multiple times just to make sure of the reading... tv does turn on and picture shows with resistor in.Leave a comment:
-
Re: Toshiba bad resistor
just reading pins volts 84mvLeave a comment:
-
Re: Toshiba bad resistor
So do the relays need replaced?Leave a comment:
-
Re: Toshiba bad resistor
coil side...Leave a comment:
-
Re: Toshiba bad resistor
one is 100.2 ohms the other is 269 ohmsLeave a comment:
-
Re: Toshiba bad resistor
yes i will check the relay now.Leave a comment:
-
Re: Toshiba bad resistor
OK so it is not a permanent replacement and I'll have to order the correct one?Leave a comment:
-
Re: Toshiba bad resistor
Someone else worked on this board... Horrible soldering and almost every point needed cleaned. Relay tested good and there is no fluctuating power at all. Idk if the horrible job that was done could have caused it but there was tons of corrosion from what looks like the rosin being left on. TV is on and working just don't know if it's safe to go up to the higher ohms.Leave a comment:
-
Toshiba bad resistor
I have a Toshiba TV that a 5w 1.8 ohm resistor went bad. All I have on hand is a 5w 3 ohm resistor. Would I be hurting anything by using this? -
Re: Philips 50PFP5332D/37 8 blink code (thermal)
The thermister sits at 70 ohms at room temp but lowered when Heated.Leave a comment:
-
Re: Philips 50PFP5332D/37 8 blink code (thermal)
Stand by shows as 7 volts. There is no measurements from vs pins.Leave a comment:
-
Re: Philips 50PFP5332D/37 8 blink code (thermal)
OK I will check it again when I get home. Last time I checked I wasn't getting any power to anything. All pins showed 0v. But that's while boards were disconnected.Leave a comment:
-
Re: Philips 50PFP5332D/37 8 blink code (thermal)
Here is the back of the TV and some closeups of the powerboats connections. Board is a LJ92-0511A....Leave a comment:
No activity results to display
Leave a comment: