The latter worked.
I uninstalled the the iball driver then updated the drivers the way you said.
Now my mouse pointer is out of prison
Thanks...
Grooby
New Member
Last Activity: 01-22-2011, 02:57 AM
Joined: 06-25-2010
Location:
-
Re: Mouse problem (should be easy)
The latter worked.
I uninstalled the the iball driver then updated the drivers the way you said.
Now my mouse pointer is out of prison
Thanks... -
Re: Mouse problem (should be easy)
Tried that already, there's nothing at all.
I am running a search for the number, I'll see what I can figure out from there.
Is there a way to get the generic driver? Like when I installed Windows 7.
I searched for iball mouse found this on my system, it my provide additional insight:
;
; pximouse.inf
; Copyright (c) 2009 Pixart Imaging Inc.
;
[Version]
Signature = "$Windows NT$"
Class = HIDClass...Last edited by Grooby; 01-20-2011, 07:30 PM.Leave a comment:
-
Mouse problem (should be easy)
I have a USB mouse that worked fine and still does on other computers, but it started to have problems immediately after I installed a windows update.
I have Windows 7 Ultimate and installed stupidly the two updates it offered yesterday which were:
_____________________________________________
[SIZE="1"]Update for Windows 7 (KB976902)
Installation date: 20/01/2011 13:20
Installation status: Successful
Update type: Important
Install this update to enable future updates... -
Re: Dell Precision 450
The reason is because on the DELL I have GPU that recommends 450w minimum, currently when that GPU is installed the computer beeps.Leave a comment:
-
Dell Precision 450
I have a Dell Precision 450 with a PSU that is 350w, I need to upgrade the PSU to a much higher one, maybe at least 450w or more but after looking online I can only seem to find the same PSU ie 350w.
Does anyone know if the Dell Precision 470 PSU fits/works with the 450? -
Re: ATI rADEON 9600XT Cap Replacement
I replaced all the caps and everything works as new, I even cleaned the fan whilst doing the cap replacements.
Thanks
Leave a comment:
-
Re: ATI rADEON 9600XT Cap Replacement
Thanks, will give you an update when they are replaced and tested.Leave a comment:
-
Re: ATI rADEON 9600XT Cap Replacement
Will do, and just to be clear:
The top link is for the FZ72 1000 6.3v replacement capacitors, and bottom for the RS 1500 6.3v replacement capacitors?
Last noob question for clarity, I see that the smaller capacitor that you linked too is 10v whilst the smaller ones that need replacing are 6.3v, does being higher voltage matter?
- Thanks for your response...Leave a comment:
-
ATI rADEON 9600XT Cap Replacement
Ok to cut a long story short I found 3 of my capacitors on my ATI RADEON 9600XT card blown (tops popped stuff sticking out).
I wanted to replace these capacitors and removed two to take to the local stores, it turned out many shops near me didn't sell them, so I left the issue and used my old card instead, however now I'm wanting to replace them again but I misplaced those two that I took to the shop
Here is a image explaining the all info I have to replace them and which caps popped:
I suspect the missing ones were the same...
No activity results to display
Leave a comment: