Re: panasonic tx-p42ut30 6 blink led problem

so if resoldering on the sc board doesnt work your sugestion moreno is to replace the mainboard?
can you please become a bit more detailed because I do not have the experience to understand many things easily.
there is a case the repair kit for tnpa 5349 to fix the problem or i must look for another board failure?
edit:
the tv doesnt turn off randomly,it just turn on for a few secs always,with a low light picture and then shuts and gives you 6 blinks

Re: panasonic tx-p42ut30 6 blink led problem

some photos my sn s board back..
the grounds seems to really need some resoldering...

Re: panasonic tx-p42ut30 6 blink led problem

will check the vsus, will pass to the next step with the gnd pads and screws and come back with new data ..
Thanks for the help Once again ..
you are really great

Re: panasonic tx-p42ut30 6 blink led problem

thanks for the advise moreno!!!
i will try the soldering and the screws and come back with the resullts..
my su board is the one with the buffers attached at the same board..
you thing i can make some measurements with multimeter also or stay in the original plan for now?

ps:if anyone have the service manual for this model It will be appreciated.
thanks a lot!!

hello guys!!!
i d like to start a thread to have a fix guide for the specific model and get some help from experts of the forum so my tv doesn t end up in the jankyard..
the sc board is the tnpa 5349 same with the s30 if i am not wrong..
the picture stays on for some secs and suts down with 6 blinks red led.
i know there is a kit for the sc board that fix the problem in most tvs of this type but before ordering it i d like to do some search if this is really the problem and not something else..
any sugestions to begin with??

Re: New Members - please post your introductions here

hello everyone...
nice to be part of your comunity