Re: Panasonic TH50PX60U 10 blinks does not power on



Thanks. I removed them but it doesn't seem to fix the problem. I also found 0V at pin 1 of p10 of the P board (supposed to be 14V). The flow chart suggests that the P board is at fault.

I've found a site that sells these parts fairly cheap so I'm probably going to just order a few boards since they do free shipping once you spend $75.

From what I understand its most likely the P board, but I am also going the order the PA board, D board, DT board, DG board, and H board.
...

Re: Panasonic TH50PX60U 10 blinks does not power on

Bump...

Any other input?

Re: Panasonic TH50PX60U 10 blinks does not power on

Bump...

Getting close to wanting to throw this thing out. Anyone else care to offer some input?

Thanks

Re: Panasonic TH50PX60U 10 blinks does not power on

So its been I a while but I have some free time to take a look at this tv again. I'll be honest I'm overwhelmed by how complicated these tv's are and don't really have the experience to go testing stuff.

The last thing I tried was the freeze test on MC201 and MC301, which was unsuccessful.

I found a P board on ebay and was considering just trying replacing it.

Does anyone have any input or recommendations?

Re: Panasonic TH50PX60U 10 blinks does not power on

Okay so I tried the freeze test on MC201, and MC301. Nothing happened unfortunately. Where to go from here?

Re: Panasonic TH50PX60U 10 blinks does not power on



Like these?

MC301


MC201 (bottom)


I'll have to pick up a can. Should the grey paste be removed first?...

So I've got this tv that stopped working a couple years ago, finally getting around to seeing if it can be fixed. When it broke down it started by randomly turning off and then one time never turned back on.

When I plug it in I hear two quick clicks, a very slight pause and then another click. The red led repeatedly blinks 10 times, no fans come on.

I've taken a couple basic electronic courses but this is my first attempt at a repair. I've found a couple flow charts that I'll try to work through but any advice or recommendations would be helpful. I only have a multi meter...

Re: New Members - please post your introductions here

Hi, joining the forum to hopefully get some help in fixing a 50" Panoramic I have lying around. Absolutely new to electronic repair, although I've taken a couple basic electronics courses as a mechanical engineering student.