Am I missing something here or what?
How does one replace a capacitor that can't be identified?

I suppose that with a new board, you could unsolder each one of them and test it it with a MFD meter and then re-solder them. But, you can't tell what the voltage rating was.

Isn't this making us a throw away society even more?
Isn't this wasting National or World resources?

If the SMD resistor manufactures can label their parts, why can't the SMD capacitor manufactures do the same? Or maybe, require a schematic of any electronic item being...

Hanns-g HC 194D. 2.5 years old. Started with 1 vertical red line after heating up.
Replaced the bulging electrolytic caps. Okay for about a month. Then it reoccurred. I found that by pressing different areas of the top circuit board attached to the LCD, it would go away. The back casing is still off. Now I get 1 vertical green line at start up which goes away. Once in a while it may reappear or a red line may.

Attached circuit board area image.
Yellow circle seems to be a good pressure point.
MAX1977.. is a regulator
AR7 unknown
AS15F... unknown...