Re: I-INC HSG1064 LED Replacement Problems

Good news, I was successful in my repair, I found a 16V supply feeding into the FETs with enough current for my needs.

Everybodys help is much appreciated, I learned a lot in the process of this repair, as this is my first repair dealing with LCD backlights.

Re: I-INC HSG1064 LED Replacement Problems



My board model is 3BS0206712GP, attached is the pictures you wanted, a top down of both sides and a shot of the ratings silkscreen....

Re: I-INC HSG1064 LED Replacement Problems

With my multimeter I read 478 ma going into the DC-DC converter powering both LED strips on the top and the bottom of the LCD. BTW In my last post I made an error, the 5.3V rail is 3.1A not 3.3A as I said.

Hello Everyone, New guy here, have a fairly simple wiring problem.

I have been in the process of repairing a 25' I-INC HSG1064 monitor that had blown CCFL bulbs and I replaced them with an LED strip kit that was available on eBay, the only problem I have had is finding a good power source.

The DC-DC converter for the LED's takes 10-30VDC, and my SMPS board has a 5.3V and a 12V output, but when I try to use the 12V output to power my DC-DC converter and my lights, it draws too much current from the SMPS and throws the monitor into a boot loop, if I am lucky it will...

Re: New Members - please post your introductions here

New guy here, Just trying to repair a monitor with failed CCFL's with new LED strips. need some help with wiring the LEDs.