Re: Samsung ue49mu6120

hello Lotas I ask you if it is possible to use one of these cards, some tv ue49mu6500u ue55mu6120 ue49mu6100kxzt instead of ue49mu6120kxzt

Re: Samsung ue49mu6120

Any other Lotas help?

Re: Samsung ue49mu6120

Hello Lotas, the TV didn't update via the internet because I didn't configure the network, I did a factory reset to correct a blue cast but then it worked and only after a couple of hours it malfunctioned until it stopped completely. the stand-by LED does not turn on the backlight works by disconnecting the main power supply.

Re: Samsung ue49mu6120

Hi Lotas, sorry I didn't tell you the result of the flash of the repaired dump right away, it worked and I turned on the tv to see if everything was ok, it worked fine for a couple of hours then the remote stopped working and turned off and turned on by itself then it stopped working, I reprogrammed the flash but it didn't work, I programmed another one removed from a samsung main board but even with that it didn't work, I checked that registers 88 and 42 were OK and that it was write protected, it doesn't work, any advice? Thank you again

Re: Samsung ue49mu6120

thanks Lotas i will try tomorrow

Re: Samsung ue49mu6120

Hi Lotas, my ue49mu6120kxzt doesn't turn on, if I unplug the power supply it turns on the backlight, the first part of the dump has many FFs and from what I've read in this forum I think the SPI is corrupted. The power went out and it happened. I also noticed that from the power supply module the 13v voltage is reduced to about 9v. I'm sending you the dump, can you please fix it? I tried to program the w25q40cl with my modified black CH341A as you recommended inserting the data you sent to iu3ohw (W25Q40CL@SOIC8 _FIX.rar) and I set the status register 0x88...