Re: Toshiba 50L1350UC Is this a bad T-con symptom?? WITH VIDEO
Hi sugar ray
The reason I asked what the voltage was . Is that I have an identical model that has no picture and the voltage I am getting is 79 volts to the panel and the board says 111 volts .
I am just trying to figure out if the voltage is too low or the panel is toast.
benq1
Member
Last Activity: 10-26-2024, 04:07 PM
Joined: 04-08-2010
Location:
-
Re: Toshiba 50L1350UC Is this a bad T-con symptom?? WITH VIDEO
Have you measured the voltage going to the LED panel?Leave a comment:
-
Re: Toshiba 50l1350uc no power
Sorry for the delay.
Voltage rating on the caps is 160 volts.The voltage on the caps is 78.7v and 78.9v.
The backlights do not come on at all. Here are 2 pics....Leave a comment:
-
Re: Toshiba 50l1350uc no power
Sorry missed Tcon...Leave a comment:
-
Re: Toshiba 50l1350uc no power
The problem with the TV is the power light comes on but nothing else. See attached photo's These are the only 2 boards....Leave a comment:
-
Re: Toshiba 50l1350uc no power
Does anyone know what the voltage for the LED panel should be? There is writing on the board saying VLED 111v 800ma DC but when I measured the voltage going to the panel it was only 79 volts. anyone know what it should be.Leave a comment:
-
Re: LED TV question!
Do you know if there is a way to test the LED screen as mine died and if a bad LED strip will cause the set not to work I need to know how to test the LED.
Thanks...Leave a comment:
-
Re: Toshiba 50l1350uc no power
Thanks
There were clips along the bottom that I missed. So far no bad caps but I have only done a visual.Leave a comment:
-
Toshiba 50l1350uc no power
Does anyone know how to open the Toshiba 50l1350uc? I have removed all the screws from the back but I am unable to open it.
Thanks,
Don -
Re: LCD 4 pin external 12v supply pinout
Thanks
It looks like the 2 pins closest to the DC IN are the ground pins and the 2 pins farthest away are the 12V pins.Leave a comment:
-
LCD 4 pin external 12v supply pinout
I received an LCD monitor with out the external power supply called One Monitor
model PV198SG. The input rating is 12V DC at 4.2 A. It has a 4 pin connector .
Does anyone have the pinout.
(see attached picture)
benq1...Last edited by benq1; 04-24-2011, 12:35 PM.
No activity results to display
Leave a comment: