Re: Fractal 1000w shut down if gaming
I found this:
[url]https://www.mikesarcade.com/cgi-bin/spies.cgi?action=url&type=info&page=psrepair.txt[/url]
"Diode failure is another common problem. There are quite a few diodes
in a switching supply and failure of any one of them will cause the
supply to blow the fuse or shut down. The most common diode failures are
shorted +12 volt or -5 volt output rectifiers. Failure of these diodes
will not blow the fuse. The supply simply detects the short and shuts
itself down."Re:...
drag
Member
Last Activity: 06-11-2017, 09:32 AM
Joined: 05-09-2016
Location: lapland
-
Re: Fractal 1000w shut down if gaming
I forgot to say that former owner said that power supply shut down randomly.
What are usually broken if power supply shut down randomly?Last edited by drag; 09-19-2016, 11:49 AM.Leave a comment:
-
Re: Fractal 1000w shut down if gaming...Leave a comment:
-
Re: Fractal 1000w shut down if gaming
It is very much similar to this picture....Leave a comment:
-
Re: Fractal 1000w shut down if gaming
It's Fractal design newton R2 1000w 80+
Model: FD-PSU-NEWT2-1000
Power supply are little broken because any other power supply works well on same computer.Last edited by drag; 09-18-2016, 11:58 AM.Leave a comment:
-
Fractal 1000w shut down if gaming
Hello, Fractal power supply works well but if i start gaming computer shut down?
I opened power supply and no bad condensator found.
Where to start finding broken parts? -
Re: [HOWTO] Fix/Repair "Chassis Intruded Fatal Error System Halted" on Asus P5QL
Accidentally wire from ATX connector disconnect but motherboard still works normal and not showing chassis intruded?
Is the wire useless?
I have wrong bios (P6T WS) if its matter.Last edited by drag; 07-24-2016, 11:35 PM.Leave a comment:
-
Re: [HOWTO] Fix/Repair "Chassis Intruded Fatal Error System Halted" on Asus P5QL
I remove the Chassis Intrusion transistor and then I run a wire from ATX connector (3.3v) to that spot and...
THAT WORKING
But Windows 10 then makes some updates and reboot and...
HORRIBLE CHASSIS INTRUDED ERROR SHOWS ITS FINAL POWERS AND APPEARS ONE MORE TIME
Then I boot again and now Asus P6T SE working almost normally
Its been a very interesting project and thanks to momaka who helped me!...Last edited by drag; 07-20-2016, 07:45 AM.Leave a comment:
-
Re: [HOWTO] Fix/Repair "Chassis Intruded Fatal Error System Halted" on Asus P5QL
I was thinking that too. But can i just take one of the orange wires? I think that all power supply wires must be connect to motherboard?...Leave a comment:
-
Re: [HOWTO] Fix/Repair "Chassis Intruded Fatal Error System Halted" on Asus P5QL
I start PC and motherboard working fine! Its not broken afterall
I not found 3.3.v supply but I found 5v. supply. Is 5v supply be good enough or is it too much?
And motherboard battery has 3v. Can I use it somehow?
I think i can remove battery case from old motherboard and connect it straight to Asus P6T SE chassis
intrusion connector....Last edited by drag; 06-20-2016, 08:17 AM.Leave a comment:
-
Re: [HOWTO] Fix/Repair "Chassis Intruded Fatal Error System Halted" on Asus P5QL
No, I search 3.3v supply but not find it and then accidentally touch something
and there was short and motherboard are broken...
Maybe someone know how to repair it....Last edited by drag; 05-29-2016, 02:10 PM.Leave a comment:
-
Re: [HOWTO] Fix/Repair "Chassis Intruded Fatal Error System Halted" on Asus P5QL
Finally after 2 hours intensive searching I find the beeping transistor on Asus P6T SE near the BIOS chip!!!!
Leave a comment:
-
Re: nvidia Geforce 9800 gt doesnt work
385f or 196 Celsius about 6-8 minutes. 8800 ultra works fine now, I put it to oven 200 C
about 7-8 min.
Leave a comment:
-
Re: [HOWTO] Fix/Repair "Chassis Intruded Fatal Error System Halted" on Asus P5QL
Chassis intrusion jumper has (propably all motherboards) +5vsb first, then empty, then chassis signal and then ground.
Th3_uN1Qu3 instructions say that "With the board powered ON, measure with your voltmeter and find the pin of the chassis intrusion switch connector that has somewhere between 1.7v and 3.3v on it.
Power the board back ON and find a 3.3v supply nearby"
I wonder that video shows +5vsb to supply?...Leave a comment:
-
Re: Sapphire HD 7770 possible short
I have r9 270x that explode yesterday. It has similar problem that PC won't boot while graphics card is plugged in. I tried Seasonic 500w and nothing happens. Then i tried Nexus
1000w and 270x one little mosfet explode...Leave a comment:
-
Re: [HOWTO] Fix/Repair "Chassis Intruded Fatal Error System Halted" on Asus P5QL
I have Asus P6T SE. Do you know how to do this repair for Asus P6T SE?...Leave a comment:
-
Re: [HOWTO] Fix/Repair "Chassis Intruded Fatal Error System Halted" on Asus P5QL
Is this good fix/repair?
[url]https://www.youtube.com/watch?v=x2cJbefy1Fc[/url]Re: [HOWTO] Fix/Repair "Chassis Intr...Jbefy1Fc[/url]Leave a comment:
-
Re: New Members - please post your introductions here
Hello, bying my first multimeter because motherboard has chassis intrusion problem..
Leave a comment:
No activity results to display
Leave a comment: