Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
s200e with right serial
I flashed the s200e file quickly from another post, but I need to write the serial from the dump (ME region). If anyone can help me or create it for me, I would appreciate it.
-
-
Re: z490-f gaming request extract fd from capsule
thank you very match , i flashed it but no post , nothing . can't understand whats wrong now...
-
z490-f gaming request extract fd from capsule
I have this bricked card, and I need to extract the FD file to write to the small 64 MB flash, the card got bricked during an update by Intel...
Leave a comment:
-
Re: z490-f gaming bricked after bios update
"It would seem that the one under the heat sink is the 25b64."
Leave a comment:
-
-
Re: z490-f gaming bricked after bios update
"Can any of you unpack the ME region from the ASUS website file?"
The other issue is identifying the correct chip. It should be one 128 and one 64, and the corrupted one is the 64."
Leave a comment:
-
Re: z490-f gaming bricked after bios update
I had to assemble a PC with this Z490-F Gaming motherboard and an i7-1700K CPU. Upon the first boot, the CPU LED was red and flashing. I understood that I needed to update the BIOS, and I performed the update using the USB flashback method. I didn't read the ASUS notice, which said, "Before BIOS update, please download Intel ME update tool from ASUS support site, and update ME firmware to Version 14.1.53.1649V1.1 to ensure optimized system settings." I updated the BIOS, and everything seemed fine until the system executed an...
Leave a comment:
-
z490-f gaming bricked after bios update
I had to assemble a PC with this Z490-F Gaming motherboard and an i7-1700K CPU. Upon the first boot, the CPU LED was red and flashing. I realized that I needed to update the BIOS. I didn't read the ASUS notice that said, "Before BIOS update, please download Intel ME update tool from ASUS support site, and update ME firmware to Version 14.1.53.1649V1.1 to ensure optimized system settings." I updated the BIOS without doing this, and everything seemed fine until the system performed an Intel ME update and shut down permanently. My attempts to reflash it were unsuccessful. Searching online,...
-
resistor identification
Please help me, I have this circuit board with a burnt resistor. There are no complete schematics available, I only found blurry photos on the web, and I have doubts about the colors....
-
Lenovo flex5 14alc05
"Laptop fallen to the ground, the fan is spinning, the side LED is flashing, the keyboard LEDs are turning on and off, and the Caps Lock LED is continuously on... What could I check?
-
Re: 820-3437 doesn't boot
done it , Resolved: I had used uninsulated jumper wire.
Leave a comment:
-
820-3437 doesn't boot
I have this MacBook Air 820-3437. The computer doesn't boot; the lights transition from green to orange, the fans are spinning, but it doesn't boot, and the Caps Lock key is off. I found corrosion on C5009 and C5003, and two pads were damaged due to the corrosion. I replaced the capacitors, connecting the positive side to R5181 pin two since the positive pad was damaged. I made a jumper connection from R5190 to the interrupted trace, and I made a jumper from the LPC_CLK24M_SMC pad to R2197. However, the issue persists. What do you suggest checking?...
-
Nokia 800 tough Ta-1189 no signal
i have no signal in 3g/4g and gps .
FM and wifi work .....
-
Re: Asus M509D need ram disable
not working .. black screen...
Leave a comment:
-
Asus M509D need ram disable
board x409dl rev 2.0 disable ram...
Leave a comment:
-
Asus M509D need ram disable
board x409dl rev 2.0 disable ram , there are any diagram avaiable ? or need to do via bios ?
-
A1286 820-2850
i have this macbook with boot problem like beep during os loading , i have the dump .
i want to program a new ic , i need new file with righ serial number...
-
-
No activity results to display
Show More
Leave a comment: