Hi, can I use a BQ24781 instead of a BQ24780? I tried and all I'm getting on the battery-side is 0.3v... It's a Gigabyte laptop

Does anybody know if its possible to change the objective lens on this microscope it comes equipped with a 2x / 4x lens and I believe it may be the reason why I cannot get a nice image on my monitor.

Re: Microscope Camera

my microscope is the AmScope SW-3T24Z Trinocular Stereo Microscope.
my microscope camera is an Eakins 14MP 1080P Digital Video HDMI or VGA Microscope Camera i listed my cameras in my original post. oh and im using the SZM CTV 1/2.

Re: Microscope Camera

I decided to bite the bullet and just hooked my system up picture in picture display so the green imaging would stop, but i'm still looking for help on why i cannot see a lot on my display. any help would be very appreciated. thank you in advance.

Hello guys, I'm having a breakdown and cannot figure this issue out!. So I've bought numerous reducers, a ctv 0.50 adapter, a new monitor and then a TV after getting frequency issues. and now an HDMI switch. Let me start from the top. The first issue i'm having is the same as most except i've purchased everything that everyone else was told to purchase and it seemed to work for everyone but myself. So the image in my eye pieces give about 5x more range to the image i receive on my TV. i called amscope who were not much help and told me I'm trying to achieve what cannot be done despite me informing...

Re: Sony CECH-ZED1U Playstation 3D LED TV - Two Red Flash

Situation: I completely lifted/torn a pad and it's trace for resistor R21, which leads to pin 7 (HOLD#)

Since then attempts have failed to yield decent results, first time I ran a trace using copper wire to that resistor it would boot fine and run for a solid ~45mins then power down with the standard red flashing, now -- in my attempt to rectify the situation by adding more strands of wire/etc the resistor came right off and is now completely lost, would anyone be able to tell me precisely what the resistors...