Re: Vestel 17MB62 Chassis
ok, serial console work!!
[CODE]UART_115200
LP_snPD
Hello U-Boot
[LGPS]: u16LongPulseThr = 07D0
[INTG]: u16IntegrationThr = 0052
[WDOG]: u8WatchDogCount = 0024
U-Boot 1.1.6 (Oct 13 2011 - 21:23:42)
Board: MSTAR TITANIA4 (CPU Speed 312 MHz)
DRAM: 128 MBytes
U-Boot is running at DRAM 0x87600000
Module: USB FAT NAND UBI UBIFS SPI JFFS2
MBOOT UNFD T4-----------------------------------------------------------20110728 21:23:41
NAND ID 20 76
...
kisspachyousee
New Member
Last Activity: 08-07-2023, 07:43 AM
Joined: 02-29-2016
Location: Italy
-
Re: Vestel 17MB62 Chassis
I can not find the correct firmware for my TV, if I knew that there was one compatible, I could try to buy a windbond programmer. would you help me?
----------edit
I seem to have realized that TX and RX for Winb25Q80 serial connection are pin 10 and 12 of the scart socket, is it correct?Last edited by kisspachyousee; 10-31-2017, 03:27 PM.Leave a comment:
-
Re: Vestel 17MB62 Chassis
I tried to freeze the chip but did not get lucky... the led when i turn on flashing.
panel is LG lc260wxn
main is 17mb62-2.6
tv is SABA model lw26a200...Leave a comment:
-
Re: Vestel 17MB62 Chassis
This is my main board...Leave a comment:
-
Re: Vestel 17MB62 Chassis
basically freezing the EEPROM is done a factory reset ?? It is brilliant! but where do I find them in my main card? I have 17mb62-2.6Leave a comment:
-
Re: Vestel 17MB62 Chassis
my problem is that the standby LED always blinks and does not turn on the TV, I changed the power, I think it is the corrupted firmware...Leave a comment:
-
Re: Vestel 17MB62 Chassis
hello, could you explain how did you update the firmware? can you do it even if you do not see anything on the screen? I have a Vestel TV that I think has the corrupted firmware!...Leave a comment:
No activity results to display
Leave a comment: