Re: Pioneer Elite VSX-33TX Receiver - Standby Only
After reviewing the schematic it looks like the Mosfet's I need to check are IC5001-IC5008. Any good recommendations to test these in circuit? Or check any different Mosfets?
I've attached the schematic photos and part numbers below.
[URL=http://s906.photobucket.com/user/italiadesigns/media/Troubleshooting/Screen%20Shot%202016-04-29%20at%209.38.39%20PM_zpsp0eee2fv.png.html][/URL]
[URL=http://s906.photobucket.com/user/italiadesigns/media/Troubleshooting/Screen%20Shot%202016-04-29%20at%209.53.14%20PM_zpsc9mdihqh.png.html][/URL]...
Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Pioneer Elite VSX-33TX Receiver - Standby Only
Hi Everyone,
I'm attempting to troubleshoot my Pioneer Elite Receiver. The standby light comes on when it's plugged in and initially when the Standby/On button is press no relay sounds can be heard. After 30 seconds to over a 1 minute when the Standby/On button is press a relay can be heard, but no power or lights on the display. I've check the fuses and confirmed they are good.
I also attempted to reset the unit by holding down the ADVANCED SURROUND button, press and hold the STANDBY/ON button for about three
seconds.
I've downloaded the service...
-
Definitive Technology SuperCube III Component Level Repair Troubleshooting Photos
Hi Everyone,
I'm attempting to troubleshoot my Definitive Technology Supercube III and proceed with component level repair if possible. I have not been able to find a DIY guide on this.
I've confirmed the amp receives power indicated by the Red LED light, however I have no sound/bass coming from the amp when I attempt to unplug and plug the RCA sub cable to the LFE input (the photo I took is testing other inputs). I have a secondary sub, which I tested to eliminate that it's an sub output receiver problem.
The board looks fairly clean except for ST tip32c...
No activity results to display
Show More
Leave a comment: