Jedi134
Member
Last Activity: 06-17-2024, 02:24 AM
Joined: 11-14-2015
Location: Wrecked
-
Result it was the squelch pot.. reading 8Meg ohm in both directions, so I swapped over too the other pin.. I'm receiving the world now...only my squelch operates in the opposite direction. Thanks for all you help anyway.... -
Thanks will have a look at them. Could it be a squelch problem, ie it's defaulted to max and is just by passing the scanned frequency??...Leave a comment:
-
[B][I]The black cap next to the heatsink with a KIA78/R09PI strapped to it. Some kind of voltage regulator. What was the fault you had to warrant replacing this cap? Looks like a 100uf 25v.[/I][/B]
[B][I]also what do these 2 pots do. RT2 and RT3
No short across antenna reading 1.4 Meg ohms[/I][/B][B][I]The black cap next to the heatsink with a KIA78/R09PI strapped to it. Some kind of voltage regulator. What was the fault you had to warrant replacing this cap? Looks like a 100uf 25v.[/I][/B]
[B][I]also what do these 2 pots do. RT2 and RT3
No short across antenna...Leave a comment:
-
Yes but I would have thought this would pick something up especially a strong radio station, I will try something else just to rule it out though....Leave a comment:
-
Yes could well be RX problem as won't grab any frequency, not even a strong local radio station, just keeps on scanning, the beep however is crystal clear..
I have uploaded some photos as asked, maybe you can point in the right direction....Leave a comment:
-
Uniden bearcat UBC 360clt no sound output
Hi I have inherited the above desktop scanner, all seems to work correctly but there is no sound output. The only sound I do get from the speaker is the beep confirmation when you press a key. No output from the headphone socket either. Not even radio static with squelch fully turned down, tried a reset by holding 2, 9, and hold buttons but still no sound, does anyone have any experience with these scanners, thanks. -
Re: UE46D7000LUXXU Banding on screen
I have seen videos on you tube showing how they can replace the bonded tabs, but no idea of cost? Surley with the amount to panels around with this type of fault, it must be feasable to get them fixed? as a new panel is 90% of the tv cost price?
[url]https://www.youtube.com/watch?v=QtY1QH120-I[/url]Re: UE46D7000LUXXU Banding on screen...lt, it must beLeave a comment:
-
Re: UE46D7000LUXXU Banding on screen
Are they repairable? and is it cost effective to do so?Leave a comment:
-
UE46D7000LUXXU Banding on screen
Hi I have these dark bands that are mostly on the left hand side of the screen and a few in the middle..Is this a panel fault and if so can it be fixed?
Am I right in saying the bonding tabs may have started to come away?... -
Re: SAMSUNG UE46D8000, small stripes problem
Old thread I know, but just out of interest do you know the model number of the panel, I have similar problems, but on the left hand side, is it a Samsung panel? LTJxxxxx
@Tom66 so this is caused by over heating LED`s? is this a manufacturing fault, how does this affect the bonded tabs?Leave a comment:
-
Re: Samsung UN55D7000LF Display issue
are these panels not repairable? Ive been told you can get the bonded tabs replaced?Leave a comment:
No activity results to display
Leave a comment: