Re: Samsung 215tw display cuts out
Can you barely see the image on the monitor? Could be inverter issue.
Razzy
Member
Last Activity: 02-21-2010, 06:00 PM
Joined: 01-28-2010
Location:
-
Re: Samsung SyncMaster 226BW
Thanks.Leave a comment:
-
Re: Samsung SyncMaster 226BW
Hmm can I just cut the leads off the old ones (while it's still soldered on the board) and just solder the new cap onto the leads? I might just do that later.Leave a comment:
-
Re: Samsung SyncMaster 226BW
I did see that on pictures of that big cap, I didn't order it. Glad I didn't either. I replaced all 6 caps, working great now. Did you use 10x25 or 12.5x20 820uF/25v?...Leave a comment:
-
Re: Samsung Syncmaster 225BW
Hooray, replaced all 6 caps, monitor all fine now. The 820 (12.5x20) barely fits, had to tilt one very slightly, the bottom of the cap is touching the other cap. Hope that's ok (but then I saw some were touching on others). Seems to be working good.
ellectronico - I'd check your wirings (inside and outside monitor).Leave a comment:
-
Re: Samsung Syncmaster 225BW
Well Gave up and ordered Panasonic FC series caps (12.5mmx20mm 820s).Leave a comment:
-
Re: Samsung Syncmaster 225BW
Two 820uF 25v - 12.5mmx20mm caps will fit this? I'm not quite sure but this is my board layout.
[url]http://i.imgur.com/73Pfz.jpg[/url]
Thanks.Re: Samsung Syncmaster 225BW<br /> ...br /> Thanks.Re: Samsung Syncmaster 225BW
Two 820uF 25v - 12.5mmx20mm caps will fit this? I'm not quite sure but this is my board layout.
[url]http://i.imgur.com/73Pfz.jpg[/url]Leave a comment:
-
Re: Samsung SyncMaster 226BW
Height from board to chassis is about 26mm...
Will 12.5mmx20mm fit on C110 and C111? I measured 10mm wide on the original caps. [url]http://i.imgur.com/73Pfz.jpg[/url]Re: Samsung SyncMaster 226BW<br /> ...3Pfz.jpg[/url]Last edited by Razzy; 01-28-2010, 08:20 PM.Leave a comment:
-
Re: Samsung SyncMaster 226BW
Whoops, I just reverfied the dimensions on the caps.. the 820uF 25v PW series is 10x25 =\ Back to drawing board....Leave a comment:
-
Re: Samsung SyncMaster 226BW
I still have one of the LCD taken apart so here are the values:
GL 105c
C725
VENT
Thanks for the response!Leave a comment:
-
Re: Samsung SyncMaster 226BW
Hello!
I have two of these LCDs with the same caps problem. I am looking for the replacement caps and I tried to order the Panasonic ones PlainBill suggested and a couple of those caps are out of stock until April/March. I've been looking around and finally found this brand Nichicon with all of them in stock at digikey.com.
UPW1H470MED
UPW1E821MPD
UPW1E331MPD6
UPW1E681MPD
Will these work ok?
I am also confused on the PlainBill's suggestions of some of these caps aren't...Last edited by Razzy; 01-28-2010, 05:01 PM.Leave a comment:
No activity results to display
Leave a comment: