After checking U14 (EEPROM) and finding it OK, I put the main PCB on my hot plate at 350* for about 10 min to reflow U11. Put board back in and TV fired right up! Go figure!!!!
...
SnapTech
New Member
Last Activity: 02-01-2025, 11:12 AM
Joined: 09-06-2015
Location: Savage, MN
-
Re: Vizio VL470M
After checking U14 (EEPROM) and finding it OK, I put the main PCB on my hot plate at 350* for about 10 min to reflow U11. Put board back in and TV fired right up! Go figure!!!!...
-
Vizio VL470M
Have a Vizio VL470M, Upon plug in, VIZIO light is yellow, no response from on button on TV. All voltages coming out of PS are good. All voltage checks on Main out are good except "inv" on is 0v. (orange wire). Any ideas? -
Samsung UN40JU6500F
Just received a Samsung UN40JU6500F and after turning on, it has a 5 blink code. After taking back cover off, found that one of the ribbon cables that is attached to the LCD panel (permanent ones) was torn. After disconnecting T-con PCB from panel, the LED backlights fired up. Anyone else seen this 5 blink code on this model? -
Re: vizio 42" bad ps need cap
The code on cap "C815" is 221 1KV. I believe it's a 220pf 1000v capacitor.Leave a comment:
-
Re: Panasonic TC-P55ST30 SNAFU'ed, SC board blown, I think...
Check Q600. If it's bad your IGBT's will blow again. Also check R608. If it reads much lower than 15K ohms, Q600 is bad.Leave a comment:
-
Re: Panasonic TC-P50S30 SC Board
I already tried that, no success.Leave a comment:
-
Panasonic TC-P50S30 SC Board
Anyone know the characteristic's of Q661 (RJP63G4) or where I can find the data sheet? -
Re: tc-p50s30 14 blinks sc short. Please help!
If you have a "14" blink issue and have replaced some of the FET's, Check "Q600" before firing up TV. I've fixed over 50 of these boards (TNPA5351) and on about half of them that MOSFET was bad. If it is bad and you start the TV, the FET's will blow again.Leave a comment:
-
Re: New Members - please post your introductions here
Hello,
My name is John and have been an Electronics Tech since 1978Leave a comment:
No activity results to display
Leave a comment: