Re: TX-P50GT30E Replace SS Board
Hello i finally changed the SS board (bought from shopjimmy) and when i plug it into my tv Showed 8 LEDs.
I verified the cable side and the flat D board
I saw that the cable flat was oxidized and after cleaning my television set is turned on.
thank for all...
picciolino
New Member
Last Activity: 04-25-2018, 09:04 AM
Joined: 09-01-2015
Location: catania
-
Re: TX-P50GT30E Replace SS Board
Thanks a lot,
I will let you know
Ciao...Leave a comment:
-
Re: TX-P50GT30E Replace SS Board
Thank you
you think that will be possible to insert the panel flat cable in the new connector of new board (AJ)?...Leave a comment:
-
Re: TX-P50GT30E Replace SS Board
Thank you a lot for your help,
below you can find the picture.
Sorry for the bad resolution, tomorrow i will resend it.
Thanks...Leave a comment:
-
TX-P50GT30E Replace SS Board
Hi All,
my tv is broken the SS-Board is dead (8 blinking led).
I tried to repair it but the Mos and the diode are good.
I need your help for replace this board.
I search the SS BOARD TNPA5331AG (board Broken)but I found on the shop jimmy store only the TNPA5331AJ.
It s possible to change the dead board "AG" with the new model board "AJ"?
What is the difference?
The board seems the same in the picture.
I suspect that the new board AJ is better than old board AG.
Can you help me?
...Last edited by picciolino; 09-21-2015, 02:57 PM. -
Re: Panasonic TX-P50GT30E 8 blinks
Hi,
how i can test the MIP391 DIP7 PANASONIC?
ThanksLeave a comment:
-
Re: Panasonic TX-P50GT30E 8 blinks (solved)
yes, I have measured Q102 and it is good, i have verified the body diode.
I don t know what is the issue....Leave a comment:
-
Re: Panasonic TX-P50GT30E 8 blinks (solved)
Hi All,
sorry for my english, i have the same tv like the same issue (8 Blinking led).
In the first time my tv had 7 blinking led, i checked the SC card and i found the short in the transistors.
I have changed with kit for SC card the DUT broken and the now my tv has a 8 blinking led.
I saw the VSUS voltage and i noted 200V this is too small because in the schematic the VSUS is 220V.
If I remove the SS card (TNPA5331) and the SS33 flat the led TV is green but the display is black.
...Leave a comment:
No activity results to display
Leave a comment: