Re: Sharp Aquos LC-60LE832U No Power or Standby Voltage
I can follow the 5v through several areas of the primary circuit but can't find any voltage on the secondary side. I've checked nearly every diode on the board. Also haven't spotted any damaged caps but haven't tested them all yet. Any ideas what I should check next? I just can't figure out where I'm losing standby power.
PsychoBob
New Member
Last Activity: 07-03-2015, 01:04 PM
Joined: 06-29-2015
Location: Huntsville, AL
-
Re: Sharp Aquos LC-60LE832U No Power or Standby Voltage
I'm experiencing the same problem from my Sharp LC60LE835U with the same power supply. I don't have any power at the main connector. I have followed the checks listed in this thread and everything is the same except I get 0.7 volts on PIN 4 of the IC.
The 6 pin part pulling down the voltage for the OP is still in tact on my board. Any guidance on next steps would be greatly appreciated.Leave a comment:
-
Re: New Members - please post your introductions here
Hello from HuntsvilleLeave a comment:
No activity results to display
Leave a comment: