the ac mains plug is burned,one leg in the board is damaged,
fixed with one leg of 1w resistor
now the "2 seconds to black"
in the inverter side have one LM358,
OZ960 ccfl controller
and a pair of double mosfet's APM9932
I measured first the mosfet's for shorts and seems to be ok,
but i tried to change with a pair of 4542 from another hyundai 17"
with no luck.
i change the lm358,but no is the problem here.
finally ,changed the OZ960 (with my 30w pencil!!!) and the monitor
now is back to life....
Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
FIX hyundai L91A
-
Re: Hp-530
I have the same board for repair,PQ 38,37,40 and 41 shorted,
there are FDS6676AS,
in my board PQ 36 and 39 are AD4684 (not sure for the brand)
and PQ 3 ,4 are AO4433
-
Re: Samsung 940b - classic nod backlight problem
you can desolder this little mosfets (8pin smd) with a little pliers.
take the ic whit the pliers and add solder to four legs on both sides,then pull up
you must add heat on both sides quickly 2 or 3 times.
just repaired one samsung syncmaster 153v , whit 2 of 4 AO4600 mosfet shorted,due to dry capacitors.
My soldering iron is a "JBC" 25W, whit soldering tip slightly curved.
sorry for my english,hahaha, i use google translator sometimes..
Leave a comment:
-
Re: Benq Q9T3 FP937s-D does not switch on
primary side is probably dead, check the mosfet , the little ic near (1200ap40) and replace the big cap ,
check too the two big resistors near
you can desolder the outputs of the transformer for easy repair and mesure on the primary side.
then , replace all caps on secondary side ,and resolder all pins on the two inverter transformers.
sorry for my english.
Leave a comment:
-
Re: Benq fp531 monitor q5t3
try change and re-program the 24c04 (not sure the same model) on the logic board.
I have one benq fp537 with same problems, now repaired.
you can search the "firmware" for the 24c04 on internet or any member of this forum.Or, try this:
[url]http://dump.elektroda.pl[/url]Re: Benq fp531 monitor q5t3<br /> <...the "firmware"
Leave a comment:
-
Re: BENQ FP91G+ no longer working - Help!!!
replace all caps on the secondary side and the big one-(100uf 400v?, line filter, on the primary) and try power on again.Sometimes , Benq boards are easy to repair.At the moment ,no need to replace the two 47 uf 50v near the power mos-fet
the circled in red is a "optocoupler" ,normally Benq mount types 817 or pc123,if are burned ,change it,it 's cost inexpensive
Look this:
[url]http://foros.zackyfiles.com/showthread.php?p=4111852[/url]
(sorry for my english)Re: BENQ FP91G+ no longer...Last edited by cpp; 11-19-2010, 10:55 AM.
Leave a comment:
-
Re: Benq FP71G+ Led Power Off
hola!!
the 8pin IC pwm controller is a ncp1200ap40?
can you post photos of your board??
thanks!
Leave a comment:
No activity results to display
Show More
Leave a comment: