Re: Dump for Lenovo ThinkPad T14S gen 2 NM-D362 Rev: 3.0
I've found the solution!
A combination of you file and the update file from the Lenovo website did the job. After reflashing with this file it worked.
I've attached the file which worked for me if someone needs it....
jega
Member
Last Activity: 04-26-2025, 02:17 AM
Joined: 06-01-2015
Location: Belgrade
-
Re: Dump for Lenovo ThinkPad T14S gen 2 NM-D362 Rev: 3.0
I've check the soldering and verified the file twice. I've also seen ME error when tried to clean it
Leave a comment:
-
Re: Dump for Lenovo ThinkPad T14S gen 2 NM-D362 Rev: 3.0
Thanks for the file! However it doesn't work. With the original bios file the laptop turns on and the backlight turns on. After a 15 seconds it resets and the cycle starts again.
With your file there is no reaction to the power on button. I've put the backup file back just to check and it works the same way as before.
Any clues?Leave a comment:
-
Re: Dump for Lenovo ThinkPad T14S gen 2 NM-D362 Rev: 3.0
U2202 dump I've attached if someone needs it for some reason.
The U2201 is a BIOS chip.
Serial number: PF-3N2P9V
Machine Type: 20WM-00B9MX...Leave a comment:
-
Dump for Lenovo ThinkPad T14S gen 2 NM-D362 Rev: 3.0
The laptop came in for not having picture on the screen after a bios update.
I need the dump file for the main bios.
Lenovo ThinkPad T14S gen 2.
HT4B1/HX3B0 NM-D362 Rev: 3.0
U2201 BIOS 25R256JV
U2202 25Q256JV...Last edited by jega; 08-12-2023, 01:08 AM. -
ECS BAT-I2 /J1900 Schematics needed
I've been requested to provide motherboard repair for several dozens of the motherboards ECS BAT-I2 /J1900 with various problems. If someone have schematics or the boardview it would be much appreciated. -
Re: hp dv6 -2020eg bios needed please
What you use to flash bios? Programmer or what? Maybe your eeprom is broken and need to be replaced. What error you recive?Leave a comment:
-
Re: Gigabyte GA-MA770-US3 - No Boot/ Fan Cycling
Hi!
You can try to measure voltage on pwr button connector on motherboard. If voltage on red wire is less then 2V then you have dead Super IO controller on motherboard. All you said indicate this is the reason of all symptoms. Try to touch super IO with finger (but carefuly after 15-20 sec after power on. It should be hot or veeeery hot.
Leave a comment:
-
Re: Please Need Y570 Bios Old have password
alihomee, did u solve it?Leave a comment:
No activity results to display
Leave a comment: