Re: Manufacturer of these caps?

Because I don't have any "original" available. Even on Farnell I was not able to find this series...

Re: Manufacturer of these caps?

There are pictures of package (detail) for info. Do somebody knows this series to confirm that is OK/NOK?...

Re: Capacitor tester

You are right - but in case you know the topology you are able to judge if the rest of parts will influence or not. These two tester I mentioned above are only "survey" testers. I'm using it since 2000 and there is not any better equipment in my workroom during repairing of electronics. I used i for million times... The discharge is needed for EVERY tester - there is only "fuse" as two anti-parallel diods on the inputs (measuring voltage less than 0,7V). For sorting GOOD/BAD is the best I have seen...

In case you want to compare...

Re: Manufacturer of these caps?

Hi.
Any tip if can be fake/real panasonic?
[url]http://www.ebay.com/itm/171193345673?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT[/url]
I measured it and cap is about 980u, ESR (AVR tester) showed 0,00R while Nippon LXZ 1000/10 showed 0,08R..
I tried to find DS, no way - somebody mentioned that is limited for MTB supplier.
Thanks!Re: Manufacturer of these caps?<br /...IDX%3AIT[/url]

Re: Capacitor tester

I'm using for few years this one - its perfect because you don't need to take CAP out of connection [url]http://zajic.cz/esr/esr.htm[/url]
I have seen similar here: [url]http://zl2pd.com/ESRmeter.html[/url]
but I haven't tested it...Re: Capacitor tester<br /> <br /> ...t tested it...Re: Capacitor tester

I'm

Re: New Members - please post your introductions here

Hello everybody. I have to say nice piece of work and knowledge concentration
Hope I can share some experience a get new ideas what to use for my designs/repairs.