Hello people.
I am after the boardview files for Asus STRIX X570-F Gaming motherboard.
Hoping someone can help me. Just got scammed on FB Marketplace and wanna have a crack at fixing it.
Thank you
vvulture
New Member
Last Activity: 04-21-2024, 07:39 PM
Joined: 04-17-2015
Location: Sydney
-
Boardview for Asus STRIX X570-F Gaming
-
AMD Radeon VII Reference Design Schematic/Boardview
Hi guys,
Would anyone here have schematics and boardview files for the reference design AMD Radeon VII board ? Need to fix fan circuitry damage.
Thank you -
Re: Dell 3008wfp faulty power supply
Oh well... thank you to all of you who tried to help, but its the end of the road for this Dell monitor.
Whilst trying to figure out the half-screen issue, my finger slipped onto one of the brown ribbon cables on top edge of screen and damaged it, causing a white line running from top to bottom on the screen. No coming back from this..
I did fix the PSU though.. might get something on ebay for it since they are so rare..
Cheers -
Re: Dell 3008wfp faulty power supply
Just an update...
I've replaced D22 and got power back.
But...
Now, only the top half of the screen works fine... the bottom half is black and displaying faint vertical lines across the entire witdh of the screen.
I have dismantled the screen one again and checked all connections which seem fine.
Any ideas ?Leave a comment:
-
Re: Dell 3008wfp faulty power supply
Thank you again selldoor.
What i've noticed is that with DMM set to 1Mohms or 10Mohms range, i get a reading across 1-2 and 2-3 regardless of the polarity of my leads.
On 1Mohms range i get :
1-2 and 2-3 0.017Mohm
1-2 and 2-3 0.029Mohm Reversed leads
On 10Mohm range i get :
1-2 and 2-3 0.02Mohm regardless of lead polarity
I don't see this on lower ohm ranges.
CheersLeave a comment:
-
Re: Dell 3008wfp faulty power supply
Thanks for the reply selldoor.
The "no reading" i was referring to is infact "OL".
1-2 Resistance ( Reversed OL )
1-3 SHORT
2-3 Resistance ( Reversed OL )
I can only set my DMM on ohms, 1kohms, 10kohms, 100kohms, 1Mohms, 10Mohms
CheersLeave a comment:
-
Re: Dell 3008wfp faulty power supply
Hi Guys,
Just removed D22 from my 3000wfp PSU.
I am trying to determine if it is infact faulty but need some advice.
Using a DMM in DIODE testing mode, i get a voltage drop of 0.158v when placing leads across Anode and Cathode.
If i reverse the leads i get zero volts ( ie no reading ).
Is this the correct way? and are the readings indicative of ok or faulty ?
I need to know before purchasing a new diode which will cost me about AU$25 .
Thank youLeave a comment:
No activity results to display
Leave a comment: