Re: Alternative Mosfet
Thanks for the replies, unfortunately i can't find a schematic, i bought the laptop liquid damaged which was what im guessing caused the mosfet to blow, since the mosfets have been removed the shorts on the board have gone.Didn't want put an incompatible mosfet on and blow something else
grendal10
Member
Last Activity: 04-07-2020, 12:29 PM
Joined: 04-15-2015
Location: conwy
-
Alternative Mosfet
hi
im trying to fiix a hp pavillion, ive found 2 shorted mosfets.Unfortunatly they have been discontinued, im trying to find an alternative but finding that most i have looked at have a lower maximum Continuous Drain Current (ta lower tc higher) would this be ok or not and wondered if anybody knew of a better alternative.im trying to replace AON6370
best replacment found so far is NVMFS4C310N.On the datasheets what do i need to make sure match on the replacement mosfet?
thanks in advance for any info given -
Re: sony lcd vertical line
lol i think ill go with the meeting with foot ideaLeave a comment:
-
Re: sony lcd vertical line
its fine i had a feeling it would be scrap and was on a fact finding mission if its broken i like to know why!
thanks for the information
Leave a comment:
-
Re: sony lcd vertical line
ok thanks, what causes the panel to fail like this? is it just age or heat?Leave a comment:
-
sony lcd vertical line
i have got an sony 40" lcd with a vertical line, im guessing its not repairable as the line remains even with the tcon disconnected, ive got access to the top ribbons but pressing on them does not affect the line in any way. just wondering what might cause it?... -
Re: Samsung LE-40R88BD turning off and on
i might have sorted it, its stayed on for the last 20mins, ive turned d-watchdog and watchdog off in the service menu. so far so good!Leave a comment:
-
Re: Samsung LE-40R88BD turning off and on
power supply model is: ip-231135aLeave a comment:
-
Re: Samsung LE-40R88BD turning off and on
could anyone tell me what pin 1 power on/off is ment to be as its currently 1.9vLeave a comment:
-
Re: Samsung LE-40R88BD turning off and on
Thanks ill give them a try and see what happensLeave a comment:
-
Samsung LE-40R88BD turning off and on
hi
wondered if anyone can help I have a Samsung LE-40R88BD which turns on and off, ive changed nearly all the capacitors on the power board and replaced the eeprom chip but no change, the screen doesnt fade as normal,
the image almost distorts before going black hope fully the pictures might help, ive fixed a few samsung tvs with bad capacitors which is why i was confused with the eeprom replacment not fixing the problem any ideas would be much appreciated... -
Re: LG 47" 47LF66 lines
im thinking the same, any likely faulty components? or would it be a replacement boardLeave a comment:
-
Re: LG 47" 47LF66 lines
are the attached any help?...Leave a comment:
-
LG 47" 47LF66 lines
ive got a LG 47" LCD TV 47LF66 which works perfectly for 2mins then the screen breaks up into vertical lines and goes blank except for a few pixels, also ive noticed the remote works when the screen is fine, when it starts to break up the remote doesnt respond, first thought it was the tcon but changed it and no difference. had a look at the powerboard and found a blown cap (25 680uf) so i replaced it and just to be on the safe side changed all the surrounding caps but still no difference, can anyone help please -
Re: failed samsung plasma panel?
just had a close look with a torch and their is a hairline crack on the screen thank you for the help im abit gutted but you've save me time and money!!Leave a comment:
-
Re: failed samsung plasma panel?
thanks ill remove the ic and see what happens, can a screen thats crack free blow a buffer board or a y sus?Leave a comment:
-
Re: failed samsung plasma panel?
not that i can see noLeave a comment:
-
failed samsung plasma panel?
Just wondered if anyone can help, ive got a 51" samsung ps51d550c thats faulty
no picture or sound led light flashes, looked inside no blown caps but found a short on one of the chips on the buffer board and im assuming the y sus board has gone as well,the logic board led flashes every 6 seconds which seems to confirm a bad y sus board , if i remove the power cable from the power board to the y sus no difference if i remove the ribbon from logic board the led flashes every second and the screen starts buzzing like its trying to power up. After all that my main question is, when i tried... -
Re: New Members - please post your introductions here
hi all
viewed this forum a few times this time i eventually got around to registering!!Leave a comment:
No activity results to display
Leave a comment: