Thanks for info....

Do these require cleaning/copying over ME region or are they good to go with just DMI info copied over ?...

Managed to bring my laptop back to life with a dump sent by SMDflea in this thread: [url]https://www.badcaps.net/forum/troubleshooting-hardware-devices-and-electronics-theory/troubleshooting-laptops-tablets-and-mobile-devices/bios-requests-only/68954-acer-e5-774g-582t-bios-dump[/url]

My question now is, how to I copy the DMI info from my dump to the one that is working but is from a different laptop ?https://Managed to bring my laptop b...ios-dump[/url]

Model: Acer F5-573G
S/N: NXGFDEP00162505F197600
Board: DAZAAMB16E0 Rev E

Laptop turns on, current draw ~540mA, every 2-3seconds jumps to ~750mA and then drops back to 540mA. Checked coil resistancies, all seem fine, no shorts that I can detect, 5V, 3.3V present. I've even converted the board to UMA but apart from lower current draw (since the dGPU isn't working) the overal behaviour is exactly the same. I'd like to try and flash a known working BIOS to rule that out as the culprit.

Current BIOS dump:...

Thank you very much. Unfortunately laptop keeps looping the same way I described. Either the PCH or the GPU is faulty....

Model: ASUS FX506HM-HN017
S/N: N7NRCX06M915297
Board: DA0NJHMBAH0 REV. H

Laptop starts up, bench power supply shows around 1.2A of current (battery disconnected), it stays there for a few seconds, then current drops to around 0.135A and the boards starts up again. Stays in this loop forever. Once every 10-15 cycles the fans start to spin at 100% and don't stop.

Checked for all the main voltages 5V, 3.3V, 1.8V etc. They are all present. No shorts that I can see. Power good signals seem to be present on the board. Battery charges. Using a thermal camera the...