Re: Identification of parts
Thanks guys. A good clean up of all joints so. The fault is when I turn in the ignition the gauge goes straight to full. Will clean them up and see
redriddick
Senior Member
Last Activity: 11-01-2019, 02:45 AM
Joined: 12-02-2014
Location: THE WOODS
-
Re: Identification of parts
Pic of readings attached. First one is the big resistor...Leave a comment:
-
Re: Identification of parts
Yes I have a multimeter. Do they need to be released from the board to test?Leave a comment:
-
Re: Identification of parts
Pics attached...Leave a comment:
-
Re: Identification of parts
Thanks will try and get a better pocLeave a comment:
-
Identification of parts
Hi guys,
A quick one for you. Can you identify the components in the attached picture for me?
It is a small board from the back of my dash (fuel gauge) on my tractor which has dual fuel tank. I think the components are busted and need to be replaced.... -
Re: Jvc led tv
Is the next step to get to the Lee's?Leave a comment:
-
Re: Jvc led tv
Not at the leds yet?Leave a comment:
-
Re: Jvc led tv
How can I find out what voltage I need to test the leds.?
I previously tested some on a different tv using 9v batteries in seriesLeave a comment:
-
Re: Jvc led tv
How can I find out what voltage I need to test the leds.?
I previously tested some on a different tv using 9v batteries in seriesLeave a comment:
-
Re: Jvc led tv
What is led tester?Leave a comment:
-
Re: Jvc led tv
Hi,
Pics attached of back of tv, psu and lcd panel number....Leave a comment:
-
Re: Jvc led tv
Morning,
Red point is 80 and drops to 36
Black point is 37 and drops to 0Leave a comment:
-
Re: Jvc led tv
Cheers budm, will try that and report backLeave a comment:
-
Jvc led tv
Hi guys,
A friend has given me a jvc led tv to fix. The tv powers up fine but there is no backlight. I have done the flashlight test and the picture is there. Of course the psu is a vestel unit but I don't think that is the problem as I have a pay that does work. Same problem with both Paul's that is leading me to think it's an led strip.
Any ideas guys?... -
Re: Speed controller for golf trolley
There is 5v to the picLeave a comment:
-
Re: Speed controller for golf trolley
The blue and red wire are where the pot and on off switch are connected.
I will have 're solder the mosfets and relay before I can test for 5v...Leave a comment:
-
Re: Speed controller for golf trolley
12c671 and 78L05A i think...Leave a comment:
-
Re: Speed controller for golf trolley
Will check them in a minLeave a comment:
-
Re: Speed controller for golf trolley
Where to start?Leave a comment:
No activity results to display
Leave a comment: