Re: Hanns-G HG281D, LCD Monitor no power

[QUOTE=jimmy1256;517346]OK. I've read all of the pages up to this point, even found the exact problem described that I have. Hanns-G 281D Rev.2. From a cold start the monitor turns on and works fine for about 3 minutes. Then black. LED indicates that its getting a signal from the computer. Using a flash light shows no image. Turn it off/on and I get the image back for about a second. So far I have replaced all of the caps on the power supply and the main board. No change. (probably not a cap issue) Not sure where to go next and am feeling...

Re: Hanns-G HG281D, LCD Monitor no power

OK. I've read all of the pages up to this point, even found the exact problem described that I have. Hanns-G 281D Rev.2. From a cold start the monitor turns on and works fine for about 3 minutes. Then black. LED indicates that its getting a signal from the computer. Using a flash light shows no image. Turn it off/on and I get the image back for about a second. So far I have replaced all of the caps on the power supply and the main board. No change. (probably not a cap issue) Not sure where to go next and am feeling a bit dejected that the...

Re: Hanns-G HG281D, LCD Monitor no power

OK. I've read all of the pages up to this point, even found the exact problem described that I have. Hanns-G 281D Rev.2. From a cold start the monitor turns on and works fine for about 3 minutes. Then black. LED indicates that its getting a signal from the computer. Using a flash light shows no image. Turn it off/on and I get the image back for about a second. So far I have replaced all of the caps on the power supply and the main board. No change. (probably not a cap issue) Not sure where to go next and am feeling a bit dejected that the...

Re: New Members - please post your introductions here

Hello repair world. I'm new here but not to the repair biz. Have 30 years experience in the office equipment service and repair world. Some computer hardware repairs as well. Also, believe it or not I have 15 years of small engine repair experience. Currently trying to save a 28" Hanns-G monitor from the land fill but not having much luck. Hopefully we can repair it together.