'Evening all!

First post to ask some assistance and hopefully a simple question - I had the C8059/C8060 cap problem on my power supply after the set died and yielded the 7 code.

I've replaced the caps per the many threads about this problem; problem is I still have the 7 code flashing at me.

My question is:

If I plug in ONLY the power connector on the power supply board, leaving all the other connectors disconnected; and then plug the set in, should the two green LED's stay lit or will they cycle off? Just looking for a quick way to determine...

Another FNG - tinkerer, biker, all-around troublemaker!

'Evening all!

I'm new to this forum but been around the 'Net for years on many forums with my "homer308" handle. I've got a cantankerous Philips plasma that thinks it has me beat; however, I resurrected it once, I can do it again! Spent $2K on it back in '06 - figure I'm at over $20 a month just to own this wonderful piece of **** - I meant "technology", not the word you were probably thinking!

Hope to learn a lot here - dunno if you were here the last time it bit the dust!...